ASE A1 TEST BANK COMPLETE SOLVED
QUESTIONS EXPERT REVIEW FULL
SOLUTION
●● Air from tail pipe during leakage test
Answer: Bad exhaust valve test
●● Heating a wrist pin will...
Answer: It will expand and not fit into rod.
●● radiator tester
Answer:
●● moderately loose alternator belt
Answer: causes squealing while accelerating
●● manifold heat control valve
Answer: forces hot exhaust gases up around the base of the carburetor
and intake manifold to warm the fuel-air mixture
●● oil cooler
Answer: prevents excessive heat and oxidization of oil
, ●● intake manifold vacuum leak
Answer: causes misfire at idle
●● Excessive valve spring height
Answer: causes valve float
●● stuck valves or improper timing
Answer: causes bent pushrods
●● Warped cylinder head surface
Answer: causes valve seat distortion/ coolant & combustion leaks
●● Heli-coil
Answer: rethreaded bolt hole
●● Measures a valve guide diameter
Answer: hole gauge or snap gauge
●● 650-800 degrees
Answer: temperature to clean iron and steel
QUESTIONS EXPERT REVIEW FULL
SOLUTION
●● Air from tail pipe during leakage test
Answer: Bad exhaust valve test
●● Heating a wrist pin will...
Answer: It will expand and not fit into rod.
●● radiator tester
Answer:
●● moderately loose alternator belt
Answer: causes squealing while accelerating
●● manifold heat control valve
Answer: forces hot exhaust gases up around the base of the carburetor
and intake manifold to warm the fuel-air mixture
●● oil cooler
Answer: prevents excessive heat and oxidization of oil
, ●● intake manifold vacuum leak
Answer: causes misfire at idle
●● Excessive valve spring height
Answer: causes valve float
●● stuck valves or improper timing
Answer: causes bent pushrods
●● Warped cylinder head surface
Answer: causes valve seat distortion/ coolant & combustion leaks
●● Heli-coil
Answer: rethreaded bolt hole
●● Measures a valve guide diameter
Answer: hole gauge or snap gauge
●● 650-800 degrees
Answer: temperature to clean iron and steel
