Set up Clearance
Give this one a try later!
The Distance from the bottom of the tool to the top surface of the part
Describe two methods for holding a work piece on a milling machine.
Give this one a try later!
The use of clamps or vises.
Identify the cutting tools that would usually be used to cut slots and grooves.
, Give this one a try later!
the endmill
Feedrate
Give this one a try later!
A code containing the letter F followed by digits.It determines the machine
slide rate of feed
Face mill
Give this one a try later!
A milling cutter that has replaceable edges
Ballnose endmill (ball endmill or ballmill)
Give this one a try later!
An endmill with a half sphere ground to fit into the outside diameter
The X-axis moves to the ______ ___ ______ from the operator.
Give this one a try later!
Give this one a try later!
The Distance from the bottom of the tool to the top surface of the part
Describe two methods for holding a work piece on a milling machine.
Give this one a try later!
The use of clamps or vises.
Identify the cutting tools that would usually be used to cut slots and grooves.
, Give this one a try later!
the endmill
Feedrate
Give this one a try later!
A code containing the letter F followed by digits.It determines the machine
slide rate of feed
Face mill
Give this one a try later!
A milling cutter that has replaceable edges
Ballnose endmill (ball endmill or ballmill)
Give this one a try later!
An endmill with a half sphere ground to fit into the outside diameter
The X-axis moves to the ______ ___ ______ from the operator.
Give this one a try later!
