Manual Data Input.
Write short programs on the fly to set up the machine.
Give this one a try later!
[MDI]
Diameter Offset.
Works with G41/G42 for Cutter Radius Compensation. (e.g. G41 X.25 D01;)
Give this one a try later!
'D' address
, Allows operator to run program.
Give this one a try later!
[MEMORY]
Flood Coolant On.
Give this one a try later!
M08
Height Offset/Length Offset.
Works with G43 to position each tool in Z axis. (e.g. G43 Z1. H03;)
Give this one a try later!
'H' address
Spindle Speed in RPM.
(e.g. S1000 M03;)
Give this one a try later!
'S' address
Write short programs on the fly to set up the machine.
Give this one a try later!
[MDI]
Diameter Offset.
Works with G41/G42 for Cutter Radius Compensation. (e.g. G41 X.25 D01;)
Give this one a try later!
'D' address
, Allows operator to run program.
Give this one a try later!
[MEMORY]
Flood Coolant On.
Give this one a try later!
M08
Height Offset/Length Offset.
Works with G43 to position each tool in Z axis. (e.g. G43 Z1. H03;)
Give this one a try later!
'H' address
Spindle Speed in RPM.
(e.g. S1000 M03;)
Give this one a try later!
'S' address
