AZ ROC TRADE EXAM B- LATEST
3 LICENSE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
How are the ends of bottom bearing joists normally laterally restrained?
- ANSWERS-Solid blocking
Tracks for structural framing shall have a minimum flange width of? -
ANSWERS-1-1/4 inches
What percentage of a wall stud can be notched in a wood framed bearing
wall in light construction? - ANSWERS-25%
What is the maximum spacing of ceiling joists in a shower with 5/8 inch
water resistant gypsum board with tile attached using adhesive? -
ANSWERS-16 inches
The molding used to finish an inside surface at a 90 degree angle is a? -
ANSWERS-Shoe molding
END OF
PAGE
1
,AZ ROC TRADE EXAM B- LATEST
3 LICENSE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
Refer to the illustration of a 2 story house w/ lap siding plans, (complete
set of plans at the test center), what is the height of the foyer in inches? -
ANSWERS-203 inches
Which of the following shall NOT be assumed to have a presumptive
load bearing capacity for foundations? - ANSWERS-Organic silt.
What is the purpose of fiber reinforced plastic or zinc coated reinforcing
bars? - ANSWERS-For corrosion resistance
The loss of slum of concrete is USUALLY due to which of the
following? - ANSWERS-Low water content
In most construction sites, water is allowed to be added to the concrete
as long as? - ANSWERS-Water and cement ratio are not exceeded.
What should be done to concrete mix to increase the ease of a pour? -
ANSWERS-Decrease rough aggregate.
END OF
PAGE
2
,AZ ROC TRADE EXAM B- LATEST
3 LICENSE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
What should be added to concrete to make it pump easier? -
ANSWERS-Hydrated lime.
Using a superplasticsizer admixer to increase the work ability of
concrete has a short lived time of? - ANSWERS-30 to 60 minutes.
On concrete masonry delivery, how long do you have before concrete
should be poured? - ANSWERS-1-1/2 hours
As the temperature of the concrete mix increases what is the effect on
the concrete mix? - ANSWERS-There is a loss in slump.
Nails used for installing Hardboard panel siding vertically must
accommodate the sheathing and penetrate the framing a minimum of
how much? - ANSWERS-1-1/2 inches
END OF
PAGE
3
, AZ ROC TRADE EXAM B- LATEST
3 LICENSE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
When framing openings in floors with a header and trimmer joists, what
maximum header joist span is allowed with a single member header? -
ANSWERS-4 feet
Above the handrail and below the head, what is the minimum clear
opening on a stairwell? - ANSWERS-36 inches
When installing vinyl siding, how much overlap should you allow for
thermal expansion? - ANSWERS-1 inch
What is the first step you should take when applying specialty finishes? -
ANSWERS-Read the manufacturers use instructions.
What is the appropriate gap between gypsum board and a tub surround?
- ANSWERS-1/4 inch
Sprayed fire resistant materials are identified by ____________ and
thickness required for a given rating. - ANSWERS-Density.
END OF
PAGE
4
3 LICENSE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
How are the ends of bottom bearing joists normally laterally restrained?
- ANSWERS-Solid blocking
Tracks for structural framing shall have a minimum flange width of? -
ANSWERS-1-1/4 inches
What percentage of a wall stud can be notched in a wood framed bearing
wall in light construction? - ANSWERS-25%
What is the maximum spacing of ceiling joists in a shower with 5/8 inch
water resistant gypsum board with tile attached using adhesive? -
ANSWERS-16 inches
The molding used to finish an inside surface at a 90 degree angle is a? -
ANSWERS-Shoe molding
END OF
PAGE
1
,AZ ROC TRADE EXAM B- LATEST
3 LICENSE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
Refer to the illustration of a 2 story house w/ lap siding plans, (complete
set of plans at the test center), what is the height of the foyer in inches? -
ANSWERS-203 inches
Which of the following shall NOT be assumed to have a presumptive
load bearing capacity for foundations? - ANSWERS-Organic silt.
What is the purpose of fiber reinforced plastic or zinc coated reinforcing
bars? - ANSWERS-For corrosion resistance
The loss of slum of concrete is USUALLY due to which of the
following? - ANSWERS-Low water content
In most construction sites, water is allowed to be added to the concrete
as long as? - ANSWERS-Water and cement ratio are not exceeded.
What should be done to concrete mix to increase the ease of a pour? -
ANSWERS-Decrease rough aggregate.
END OF
PAGE
2
,AZ ROC TRADE EXAM B- LATEST
3 LICENSE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
What should be added to concrete to make it pump easier? -
ANSWERS-Hydrated lime.
Using a superplasticsizer admixer to increase the work ability of
concrete has a short lived time of? - ANSWERS-30 to 60 minutes.
On concrete masonry delivery, how long do you have before concrete
should be poured? - ANSWERS-1-1/2 hours
As the temperature of the concrete mix increases what is the effect on
the concrete mix? - ANSWERS-There is a loss in slump.
Nails used for installing Hardboard panel siding vertically must
accommodate the sheathing and penetrate the framing a minimum of
how much? - ANSWERS-1-1/2 inches
END OF
PAGE
3
, AZ ROC TRADE EXAM B- LATEST
3 LICENSE EXAM
QUESTIONS AND
ANSWERS 2026 - 2027
When framing openings in floors with a header and trimmer joists, what
maximum header joist span is allowed with a single member header? -
ANSWERS-4 feet
Above the handrail and below the head, what is the minimum clear
opening on a stairwell? - ANSWERS-36 inches
When installing vinyl siding, how much overlap should you allow for
thermal expansion? - ANSWERS-1 inch
What is the first step you should take when applying specialty finishes? -
ANSWERS-Read the manufacturers use instructions.
What is the appropriate gap between gypsum board and a tub surround?
- ANSWERS-1/4 inch
Sprayed fire resistant materials are identified by ____________ and
thickness required for a given rating. - ANSWERS-Density.
END OF
PAGE
4
