IPC J-STD-001 J SECTION 1 EXAM
QUESTIONS AND ANSWERS
Defects SHALL be identified, documented, and dispositioned by the Manufacturer
based on the design, service and User requirements. - ANSWERS[D1D2D3]
Hardware found to be produced using either materials or process that do not conform to
the requirements of this standard SHALL be classified as defects and dispositioned. -
ANSWERS[D1D2D3]
This disposition SHALL address the potential effect of the nonconformance on
functional capability of the hardware such as reliability and design life (longevity). -
ANSWERS[D1D2D3]
Specialized processes and/or technologies not specified herein SHALL be performed in
accordance with documented procedures which are available for review. -
ANSWERS[N1D2D3]
The external interconnect points, e.g., terminals, pins, SHALL meet the solderability
requirements of 4.1 Solderability. - ANSWERS[D1D2D3]
Unless the engineering documentation provides additional instruction on broken or
damaged strands, there SHALL NOT be any broken or damaged strands for wires
identified as being high voltage/high current. - ANSWERS[D1D2D3]
Manufacturers of Class 3 products SHALL develop and implement a documented
process control system. - ANSWERS[N1N2D3]
A documented process control system, if established, SHALL define process control
and corrective action limits. - ANSWERS[N1D2D3]
Process control methodologies SHALL be used in the planning, implementation and
evaluation of the manufacturing processes used to produce soldered electrical and
electronic assemblies. - ANSWERS[N1D2D3]
When a decision or requirement is to use a documented process control system, failure
to implement process corrective action and/or the use of continually ineffective
corrective actions SHALL be grounds for disapproval of the process and associated
documentation. - ANSWERS[N1D2D3]
When a statistical process control system process is used, it SHALL include the
following elements at a minimum:
a. Training is provided to personnel with assigned responsibilities ...
QUESTIONS AND ANSWERS
Defects SHALL be identified, documented, and dispositioned by the Manufacturer
based on the design, service and User requirements. - ANSWERS[D1D2D3]
Hardware found to be produced using either materials or process that do not conform to
the requirements of this standard SHALL be classified as defects and dispositioned. -
ANSWERS[D1D2D3]
This disposition SHALL address the potential effect of the nonconformance on
functional capability of the hardware such as reliability and design life (longevity). -
ANSWERS[D1D2D3]
Specialized processes and/or technologies not specified herein SHALL be performed in
accordance with documented procedures which are available for review. -
ANSWERS[N1D2D3]
The external interconnect points, e.g., terminals, pins, SHALL meet the solderability
requirements of 4.1 Solderability. - ANSWERS[D1D2D3]
Unless the engineering documentation provides additional instruction on broken or
damaged strands, there SHALL NOT be any broken or damaged strands for wires
identified as being high voltage/high current. - ANSWERS[D1D2D3]
Manufacturers of Class 3 products SHALL develop and implement a documented
process control system. - ANSWERS[N1N2D3]
A documented process control system, if established, SHALL define process control
and corrective action limits. - ANSWERS[N1D2D3]
Process control methodologies SHALL be used in the planning, implementation and
evaluation of the manufacturing processes used to produce soldered electrical and
electronic assemblies. - ANSWERS[N1D2D3]
When a decision or requirement is to use a documented process control system, failure
to implement process corrective action and/or the use of continually ineffective
corrective actions SHALL be grounds for disapproval of the process and associated
documentation. - ANSWERS[N1D2D3]
When a statistical process control system process is used, it SHALL include the
following elements at a minimum:
a. Training is provided to personnel with assigned responsibilities ...
