Year 1 Final Exam JATC EXAM (2026) || Most Recent
Exam 2026-2027 Actual Complete Real Exam Questions
And Correct Answers (Verified Answers) Already
Graded A+ | Guaranteed Success!! Newest Exam |
Just Released!!
The most common center bend angle for a three-bend saddle is
? . - ANSWER-
45°
Which of the following measurements must be known before a
three-bend saddle can be fabricated? - ANSWER-Distance to
the center of the obstruction Obstruction rise
A four-bend saddle uses standard offset multipliers. - ANSWER-
True
A three-bend saddle will typically use a shrink constant
of 3/16 inch. -
ANSWER-
True
? associated with the flow of current in a conductor is one of
the most significant factors to be considered in designing
electrical systems. The conductor's rating is dependent upon
its type of ? . - ANSWER-Heat / electrical insulation
,Conductors are assigned a ? ampacity that reflects the
insulation's ability to
handle and dissipate heat under ? conditions. - ANSWER-
specific / varying
The specific insulation types listed for use in wet locations
contain the letter ? in
the type designator. -
ANSWER-W
The common factors that can contribute to conductor
insulation degradation because of excessive operating
temperature are the ? temperature in which the conductor
insulation shall operate, the ? heat created in the conductor as
a result of current flow, the dissipation rate of the heat into the
surrounding environment, and the heat generated by adjacent
current-carrying conductors. - ANSWER-ambient / internal
Copper conductors are available as hard-drawn, medium-hard-
drawn, and softdrawn. Hard-drawn copper has the greatest
strength, but is difficult to work with.
Because of the difficulty in shaping hard-drawn copper, its
uses are limited. -
ANSWER-
True
A Journeyman is told to run a three-inch conduit across a room
and decides to use a channel-iron system. The apprentice
, suggests that one-hole straps might be quicker. What might
happen? - ANSWER-The Journeyman should explain the
reasoning behind his or her decision. The apprentice should
respect the Journeyman's experience and should defer to the
Journeyman.
? is a keen sense of what to do or say in order to maintain good
relations with
others or avoid offense. -
ANSWER-tact
Two causes of accidents can best be described as ? . -
ANSWER-unsafe acts /
unsafe
conditions
Which of the following is an unsafe act that might be found
with ladders? -
ANSWER-overreaching from a
ladder
Which of the following is an unsafe act that might be found
with ladders? -
ANSWER-carrying to heavy of a load up
the ladder
A ladder top should extend at least ? above the roof edge of
a building when
Exam 2026-2027 Actual Complete Real Exam Questions
And Correct Answers (Verified Answers) Already
Graded A+ | Guaranteed Success!! Newest Exam |
Just Released!!
The most common center bend angle for a three-bend saddle is
? . - ANSWER-
45°
Which of the following measurements must be known before a
three-bend saddle can be fabricated? - ANSWER-Distance to
the center of the obstruction Obstruction rise
A four-bend saddle uses standard offset multipliers. - ANSWER-
True
A three-bend saddle will typically use a shrink constant
of 3/16 inch. -
ANSWER-
True
? associated with the flow of current in a conductor is one of
the most significant factors to be considered in designing
electrical systems. The conductor's rating is dependent upon
its type of ? . - ANSWER-Heat / electrical insulation
,Conductors are assigned a ? ampacity that reflects the
insulation's ability to
handle and dissipate heat under ? conditions. - ANSWER-
specific / varying
The specific insulation types listed for use in wet locations
contain the letter ? in
the type designator. -
ANSWER-W
The common factors that can contribute to conductor
insulation degradation because of excessive operating
temperature are the ? temperature in which the conductor
insulation shall operate, the ? heat created in the conductor as
a result of current flow, the dissipation rate of the heat into the
surrounding environment, and the heat generated by adjacent
current-carrying conductors. - ANSWER-ambient / internal
Copper conductors are available as hard-drawn, medium-hard-
drawn, and softdrawn. Hard-drawn copper has the greatest
strength, but is difficult to work with.
Because of the difficulty in shaping hard-drawn copper, its
uses are limited. -
ANSWER-
True
A Journeyman is told to run a three-inch conduit across a room
and decides to use a channel-iron system. The apprentice
, suggests that one-hole straps might be quicker. What might
happen? - ANSWER-The Journeyman should explain the
reasoning behind his or her decision. The apprentice should
respect the Journeyman's experience and should defer to the
Journeyman.
? is a keen sense of what to do or say in order to maintain good
relations with
others or avoid offense. -
ANSWER-tact
Two causes of accidents can best be described as ? . -
ANSWER-unsafe acts /
unsafe
conditions
Which of the following is an unsafe act that might be found
with ladders? -
ANSWER-overreaching from a
ladder
Which of the following is an unsafe act that might be found
with ladders? -
ANSWER-carrying to heavy of a load up
the ladder
A ladder top should extend at least ? above the roof edge of
a building when
