Automotive Networking, CAN Bus Diagnostics &
Electronic Control Systems Study Guide
what is the resistance of the terminating resistor on networks equipped with one start
connector? - correct answers -60 ohms
with the bus active and no faults present, what voltages should be measured on CAN-C(+)? -
correct answers -approximately 3.2v
what Atlantis-high network uses splice block connectors? - correct answers -CAN-BH
with the bus active and no faults present, what voltages should be measured on CAN-B(-)? -
correct answers -approximately 0.4v
which resource should be used first for troubleshooting DRB III Emulator concerns? - correct
answers -wiTECH knowledge base
with the bus active and no faults present, what voltages should be measured on LIN? - correct
answers -7.0v-10.0v
what electrical architecture requires the use of the mopar diagnostic pod (MPD) for diagnostics?
- correct answers -Atlantis-high
which of the following scan tool functions ate prevented if a security gateway (SGW) becomes
locked? select all that apply. - correct answers -start an actuator
run a system test
1