ACI EXAM SCRIPT 2026 COMPLETE
QUESTIONS AND VERIFIED ANSWERS
◉The thermometer must remain in the concrete during the
measurement for a minimum of ______ minutes. In addition, the
temperature measurement must be completed within _______
minutes after obtaining the sample.. Answer: 2, 5
◉The temperature of freshly mixed concrete is measured and
recorded to the nearest _____. Answer: 1 degree
◉SLUMP TEST. Answer:
◉****The slump test does not provide an indication of the water
content of a concrete mixture.. Answer: F
◉A slump mold can be fabricated from both plastic and metal..
Answer: T
◉****The length of the tamping for the slump test shall be
approximately. Answer:
, ◉The slump test is applicable to concrete having a coarse aggregate
up to _______ inch in size.. Answer: 1.5 inches
◉The height of the slump cone is. Answer: 12 in
◉6. The exterior of the slump cone is tapped 10 to 15 times after
rodding each layer.. Answer: F
◉The slump mold is filled with three layers of concrete. Answer: by
volume
◉8. If the top surface of the concrete falls below the top of the slump
cone while rodding the final layer of concrete,. Answer: stop, add
concrete to maintain an excess, then continue the rod count from
where you left off.
◉Raise the mold vertically a distance of 12 inches. Answer:
in5±2seconds
◉The slump of a mixture is found by. Answer: measuring the vertical
distance to the displaced original center on the top
surface of the slumped concrete.
◉AIR CONTENT BY PRESSURE METHOD. Answer:
QUESTIONS AND VERIFIED ANSWERS
◉The thermometer must remain in the concrete during the
measurement for a minimum of ______ minutes. In addition, the
temperature measurement must be completed within _______
minutes after obtaining the sample.. Answer: 2, 5
◉The temperature of freshly mixed concrete is measured and
recorded to the nearest _____. Answer: 1 degree
◉SLUMP TEST. Answer:
◉****The slump test does not provide an indication of the water
content of a concrete mixture.. Answer: F
◉A slump mold can be fabricated from both plastic and metal..
Answer: T
◉****The length of the tamping for the slump test shall be
approximately. Answer:
, ◉The slump test is applicable to concrete having a coarse aggregate
up to _______ inch in size.. Answer: 1.5 inches
◉The height of the slump cone is. Answer: 12 in
◉6. The exterior of the slump cone is tapped 10 to 15 times after
rodding each layer.. Answer: F
◉The slump mold is filled with three layers of concrete. Answer: by
volume
◉8. If the top surface of the concrete falls below the top of the slump
cone while rodding the final layer of concrete,. Answer: stop, add
concrete to maintain an excess, then continue the rod count from
where you left off.
◉Raise the mold vertically a distance of 12 inches. Answer:
in5±2seconds
◉The slump of a mixture is found by. Answer: measuring the vertical
distance to the displaced original center on the top
surface of the slumped concrete.
◉AIR CONTENT BY PRESSURE METHOD. Answer:
