Bmw Members Test Exam Questions And Answers Verified 100% Correct

BMW MEMBERS TEST EXAM QUESTIONS AND ANSWERS VERIFIED 100% CORRECT DSC equipped vehicle deactivates traction when it's cold outside. True or false? - ANSWER -False 0.1 ohms is shown at the injectors. What could be the cause? - ANSWER -Short injector A vehicle with a spongy pedal with leaking fluid slowly sinks to the floor. What could be the cause? - ANSWER -Primary seal is bad A vehicle comes in with a concert of stiff pedal when pressing rapidly. What could be the cause? - ANSWER -Check valve When you press the brake pedal in and it releases the brake booster hard. What could be the cause? - ANSWER -Vent port A diagram shows 50 on one end and 110 on the other with different alignment angles. What would it cause? - ANSWER -Pulling to the left Does a vehicle always pull to the most positive caster and negative camber. True or false? - ANSWER -False A bent strut mount can affect camber angle/alignment. True or false? - ANSWER -True A vehicle comes in with a engine over heating concern during load but goes away at idle. What could be the cause? - ANSWER -Restriction in coolant radiator hose. what is used to measure key off battery drain ? - ANSWER -Amp clamp Vanos solenoid can cause a no start. True or false? - ANSWER -False What can be the cause of clunking noise in front of the car? - ANSWER -Worn or Damaged stabilizer link Tech a says over torqued ball joint nut can cause damage to the ball joint stud , Tech B says that out of round knuckle hole can cause damage to ball joint stud - ANSWER -Both Bucking on freeway concerns can be caused by? - ANSWER -Fuel delivery steering wheel Jerks every half of a turn. What can be the cause? - ANSWER Faulty steering column U Joint Cooling system overheats after servicing. What can be the cause - ANSWER -Air in the system infinite resistance on wheel speed sensor and constant 12v by wheel speed means that they are - ANSWER -Faulty AC circuit blows fuse right away. What can be the cause? - ANSWER -Shorted AC clutch Tech A says DSC uses steering wheel angle as input, Tech b says DSC uses brake light switch as input - ANSWER -Both ECT temperature gauge not working. What can be the cause? - ANSWER -Faulty KOMBI The reading on the micrometer shown above is ? - ANSWER -6.5mm What causes brake pulsation? - ANSWER -Variation thickness of brake rotor A wheel bearing can cause a DSC fault. True or False? - ANSWER -True 3 wheel shows 24 miles and 1 is 23, what can be the cause? - ANSWER -Bad wheel bearing In a parallel circuit it shows three bulbs that aren't operating. What can be the cause ? - ANSWER -Open from Y TO Z An XDrive vehicle equipped with a transfer case makes a clunking noise during accelerating and braking. What could be the cause? - ANSWER -Loose Chain A vehicle comes in with a faulty differential. The fluid is overfilled and creamy, what could be the cause? - ANSWER -Water in the fluid A vehicle comes in with a concern of a clunking sound from the rear during a braking and accelerating. What is the most likely cause? - ANSWER -Thrust Arm A circuit shows a radio that is inoperative on the power outlet side. What could be the cause? - ANSWER -Bad Fuse