AT 308 study correct 100%
You are unfamiliar with a machine or tool. - ANSWERAsk instructor or TA
You noticed that lab equipment is damaged or broken. - ANSWERNotify instructor or
TA
In what situation do you try to drill holes in parts located on your hand? -
ANSWERNever
Use common sense during lab session. - ANSWERTRUE
Magnification used by the optical comparator in the AT308 lab is X10. Do you need
to divide measurement given by the digital readout by 10 to get actual
measurement? - ANSWERNO
When using the digital readout optical comparator to determine an angle, how many
times will you enter a location at the control (excluding an optional reference point)? -
ANSWERDO NOT ANSWER Two
When using the digital readout optical comparator to determine a radius, how many
times will you enter a location at the control (excluding an optional reference point)? -
ANSWERthree
Use of both types of lighting (profile lighting and surface illumination) at the same
time gives more precise measurements. - ANSWERfalse
Strain is an example of a: - ANSWERMechanical property
Yield point is an example of a: - ANSWERDO NOT ANSWER chemical property
Hardness is an example of a: - ANSWERDO NOT ANSWER Physical property
Electrical Conductivity is an example of a: - ANSWERPhysical property
Specific Gravity is an example of a: - ANSWERDO NOT ANSWER Rational property
Resistance to oxidation is an example of a: - ANSWERResistance to oxidation is an
example of a:
Stress is: - ANSWERLoad over area
Which of the following is standard system unit used for load? - ANSWERPounds
(lbs)
Abrupt changes in dimensions of a part usually cause _____________ in stresses. -
ANSWERIncrease
You are unfamiliar with a machine or tool. - ANSWERAsk instructor or TA
You noticed that lab equipment is damaged or broken. - ANSWERNotify instructor or
TA
In what situation do you try to drill holes in parts located on your hand? -
ANSWERNever
Use common sense during lab session. - ANSWERTRUE
Magnification used by the optical comparator in the AT308 lab is X10. Do you need
to divide measurement given by the digital readout by 10 to get actual
measurement? - ANSWERNO
When using the digital readout optical comparator to determine an angle, how many
times will you enter a location at the control (excluding an optional reference point)? -
ANSWERDO NOT ANSWER Two
When using the digital readout optical comparator to determine a radius, how many
times will you enter a location at the control (excluding an optional reference point)? -
ANSWERthree
Use of both types of lighting (profile lighting and surface illumination) at the same
time gives more precise measurements. - ANSWERfalse
Strain is an example of a: - ANSWERMechanical property
Yield point is an example of a: - ANSWERDO NOT ANSWER chemical property
Hardness is an example of a: - ANSWERDO NOT ANSWER Physical property
Electrical Conductivity is an example of a: - ANSWERPhysical property
Specific Gravity is an example of a: - ANSWERDO NOT ANSWER Rational property
Resistance to oxidation is an example of a: - ANSWERResistance to oxidation is an
example of a:
Stress is: - ANSWERLoad over area
Which of the following is standard system unit used for load? - ANSWERPounds
(lbs)
Abrupt changes in dimensions of a part usually cause _____________ in stresses. -
ANSWERIncrease
