Arizona Plans Examiner Certification
Exam Practice Questions And Correct
Answers (Verified Answers) Plus
Rationale 2026 Q&A| Instant Download
Pdf
1. A registered Plans Examiner in Arizona is primarily responsible for
ensuring that submitted building plans comply with which set of
standards?
A. International Building Code (IBC)
B. Arizona State and local building codes
C. National Fire Protection Association (NFPA) standards only
D. Occupational Safety and Health Administration (OSHA) guidelines
Rationale: The core responsibility of a Plans Examiner in Arizona is to
verify that plans meet the adopted Arizona State and applicable local
building regulations.
2. When reviewing structural plans, which document must a Plans
Examiner verify for compliance with wind load requirements?
A. International Plumbing Code
B. International Building Code (IBC)
C. Uniform Mechanical Code
D. National Electrical Code
Rationale: Wind load requirements are specified within the structural
, provisions of the International Building Code, which must be checked
during plan review.
3. In Arizona, what is the minimum live load requirement for residential
roof design in areas subject to snow in the IBC?
A. 10 psf
B. 20 psf
C. 30 psf
D. 40 psf
Rationale: The IBC establishes a minimum roof live load of 20 pounds
per square foot in snow areas, which must be verified during plan
review.
4. Which fire-resistance rating is required for exterior walls of a building
located less than 5 feet from the property line in Arizona?
A. 0 hours
B. 1 hour
C. 2 hours
D. 3 hours
Rationale: Exterior walls close to property lines are required to have
increased fire-resistance ratings per code to limit fire spread between
properties.
5. For an assembly occupancy with an occupant load of 150, what is the
minimum number of exits required according to the IBC?
A. 1
B. 2
C. 3
D. 4
Rationale: The IBC requires at least two means of egress for occupant
loads over 50 in assembly occupancies.
, 6. A Plans Examiner should verify that egress doors in commercial
buildings have a minimum clear width of:
A. 24 inches
B. 30 inches
C. 32 inches
D. 36 inches
Rationale: The IBC mandates a minimum net clear width of 32 inches
for egress doors in commercial use.
7. What is the maximum allowed travel distance to an exit in a
sprinklered business occupancy?
A. 100 feet
B. 150 feet
C. 200 feet
D. 250 feet
Rationale: In sprinklered business occupancies, the IBC permits up to
150 feet of travel distance to an exit.
8. Under Arizona code, which type of construction provides the highest
level of fire resistance?
A. Type III
B. Type II
C. Type I
D. Type V
Rationale: Type I construction uses noncombustible materials with
the highest fire-resistance ratings assigned by the IBC.
9. When reviewing accessibility provisions, a Plans Examiner must ensure
that at least what percentage of parking spaces in a public facility are
designated accessible?
A. 2%
B. 4%
Exam Practice Questions And Correct
Answers (Verified Answers) Plus
Rationale 2026 Q&A| Instant Download
1. A registered Plans Examiner in Arizona is primarily responsible for
ensuring that submitted building plans comply with which set of
standards?
A. International Building Code (IBC)
B. Arizona State and local building codes
C. National Fire Protection Association (NFPA) standards only
D. Occupational Safety and Health Administration (OSHA) guidelines
Rationale: The core responsibility of a Plans Examiner in Arizona is to
verify that plans meet the adopted Arizona State and applicable local
building regulations.
2. When reviewing structural plans, which document must a Plans
Examiner verify for compliance with wind load requirements?
A. International Plumbing Code
B. International Building Code (IBC)
C. Uniform Mechanical Code
D. National Electrical Code
Rationale: Wind load requirements are specified within the structural
, provisions of the International Building Code, which must be checked
during plan review.
3. In Arizona, what is the minimum live load requirement for residential
roof design in areas subject to snow in the IBC?
A. 10 psf
B. 20 psf
C. 30 psf
D. 40 psf
Rationale: The IBC establishes a minimum roof live load of 20 pounds
per square foot in snow areas, which must be verified during plan
review.
4. Which fire-resistance rating is required for exterior walls of a building
located less than 5 feet from the property line in Arizona?
A. 0 hours
B. 1 hour
C. 2 hours
D. 3 hours
Rationale: Exterior walls close to property lines are required to have
increased fire-resistance ratings per code to limit fire spread between
properties.
5. For an assembly occupancy with an occupant load of 150, what is the
minimum number of exits required according to the IBC?
A. 1
B. 2
C. 3
D. 4
Rationale: The IBC requires at least two means of egress for occupant
loads over 50 in assembly occupancies.
, 6. A Plans Examiner should verify that egress doors in commercial
buildings have a minimum clear width of:
A. 24 inches
B. 30 inches
C. 32 inches
D. 36 inches
Rationale: The IBC mandates a minimum net clear width of 32 inches
for egress doors in commercial use.
7. What is the maximum allowed travel distance to an exit in a
sprinklered business occupancy?
A. 100 feet
B. 150 feet
C. 200 feet
D. 250 feet
Rationale: In sprinklered business occupancies, the IBC permits up to
150 feet of travel distance to an exit.
8. Under Arizona code, which type of construction provides the highest
level of fire resistance?
A. Type III
B. Type II
C. Type I
D. Type V
Rationale: Type I construction uses noncombustible materials with
the highest fire-resistance ratings assigned by the IBC.
9. When reviewing accessibility provisions, a Plans Examiner must ensure
that at least what percentage of parking spaces in a public facility are
designated accessible?
A. 2%
B. 4%
