Arizona Electrical Inspector Certification
Exam Practice Questions And Correct
Answers (Verified Answers) Plus
Rationale 2026 Q&A| Instant Download
Pdf
1. Which of the following is the primary purpose of the National
Electrical Code (NEC)?
A. To increase electrical installation costs
B. To establish minimum standards for safe electrical installations
C. To provide optional guidelines for electrical design
D. To replace local building codes
The NEC is adopted to set minimum safety standards that protect
persons and property from electrical hazards.
2. According to the NEC, what is the maximum allowable voltage drop
for branch circuits to maintain efficient operation?
A. 2%
B. 3%
C. 5%
D. 10%
The NEC recommends a maximum of 3% voltage drop on branch
circuits to ensure proper performance of electrical equipment.
,3. Grounding electrode conductors must be sized based on the size of
the service entrance conductor. What is the minimum requirement
for a #4 AWG copper grounding electrode conductor for a 200 A
service?
A. #8 AWG copper
B. #6 AWG copper
C. #4 AWG copper
D. #2 AWG copper
The NEC requires that the grounding electrode conductor not be
reduced in size below that of the service entrance conductor, making
#4 AWG copper acceptable for a 200 A service.
4. Which type of conduit is nonmetallic and commonly used in
underground installations?
A. EMT
B. PVC
C. RMC
D. IMC
PVC conduit is widely used underground due to its corrosion
resistance and ease of installation.
5. In residential occupancies, what is the minimum number of 20 A
small-appliance branch circuits required by the NEC?
A. One
B. Two
C. Three
D. Four
The NEC requires at least two 20 A small appliance branch circuits to
serve kitchen receptacles.
6. What is the NEC requirement for receptacle spacing in dwelling unit
living rooms?
, A. One every 20 ft
B. One every 10 ft
C. No point along the floor line shall be more than 6 ft from a
receptacle
D. One per wall
Receptacle spacing is based on a 6 ft rule along any wall to minimize
the use of extension cords.
7. A 480 V three-phase panelboard has a service disconnect rated at
225 A. What is the minimum conductor ampacity required?
A. 150 A
B. 175 A
C. 225 A
D. 250 A
Conductors must be rated at least equal to the service disconnect
rating to safely carry the load.
8. What does GFCI protection primarily protect against?
A. Overloads
B. Short circuits
C. Ground faults
D. High voltage spikes
Ground Fault Circuit Interrupters (GFCIs) detect differences in current
and open the circuit to prevent shock.
9. In commercial occupancies, what is the required minimum
illumination level in a corridor?
A. 5 fc
B. 10 fc
C. 1 fc
D. 15 fc
Exam Practice Questions And Correct
Answers (Verified Answers) Plus
Rationale 2026 Q&A| Instant Download
1. Which of the following is the primary purpose of the National
Electrical Code (NEC)?
A. To increase electrical installation costs
B. To establish minimum standards for safe electrical installations
C. To provide optional guidelines for electrical design
D. To replace local building codes
The NEC is adopted to set minimum safety standards that protect
persons and property from electrical hazards.
2. According to the NEC, what is the maximum allowable voltage drop
for branch circuits to maintain efficient operation?
A. 2%
B. 3%
C. 5%
D. 10%
The NEC recommends a maximum of 3% voltage drop on branch
circuits to ensure proper performance of electrical equipment.
,3. Grounding electrode conductors must be sized based on the size of
the service entrance conductor. What is the minimum requirement
for a #4 AWG copper grounding electrode conductor for a 200 A
service?
A. #8 AWG copper
B. #6 AWG copper
C. #4 AWG copper
D. #2 AWG copper
The NEC requires that the grounding electrode conductor not be
reduced in size below that of the service entrance conductor, making
#4 AWG copper acceptable for a 200 A service.
4. Which type of conduit is nonmetallic and commonly used in
underground installations?
A. EMT
B. PVC
C. RMC
D. IMC
PVC conduit is widely used underground due to its corrosion
resistance and ease of installation.
5. In residential occupancies, what is the minimum number of 20 A
small-appliance branch circuits required by the NEC?
A. One
B. Two
C. Three
D. Four
The NEC requires at least two 20 A small appliance branch circuits to
serve kitchen receptacles.
6. What is the NEC requirement for receptacle spacing in dwelling unit
living rooms?
, A. One every 20 ft
B. One every 10 ft
C. No point along the floor line shall be more than 6 ft from a
receptacle
D. One per wall
Receptacle spacing is based on a 6 ft rule along any wall to minimize
the use of extension cords.
7. A 480 V three-phase panelboard has a service disconnect rated at
225 A. What is the minimum conductor ampacity required?
A. 150 A
B. 175 A
C. 225 A
D. 250 A
Conductors must be rated at least equal to the service disconnect
rating to safely carry the load.
8. What does GFCI protection primarily protect against?
A. Overloads
B. Short circuits
C. Ground faults
D. High voltage spikes
Ground Fault Circuit Interrupters (GFCIs) detect differences in current
and open the circuit to prevent shock.
9. In commercial occupancies, what is the required minimum
illumination level in a corridor?
A. 5 fc
B. 10 fc
C. 1 fc
D. 15 fc
