Csx Question and answers verified to
pass 2025/2026
What is the leading cause of injuries? - correct answer ✔Slip, trips and falls
Getting off equipment - correct answer ✔Stop at the bottom step or ladder rung to observe where you
are going to place yout feet.
Maintain 3 points of contact and do not let go of the handrails
Ensure both feet are firmly on the ground or floor
Employees less than 1 year - correct answer ✔Required to apply lime green reflective stripes to their
hard hats.
Walking on locomotive running boards - correct answer ✔Always use the handrails
What is the min. distance you must maintain when near standing cars? - correct answer ✔25 Feet (GS-
10)
What are common hazards in the mechanical department? - correct answer ✔Red Zones and Pinch
points
What zones should you be aware of when working in the mechanical department? - correct answer
✔Extended red zones
What is the required distance that must be kept when material is being handled by boom trucks and
backhoes? - correct answer ✔10 Feet
, What do overhead cranes create? - correct answer ✔Additional red zones
Mechanical employees are required : - correct answer ✔To use hand guard protection devieces for all
stricking tools in order to prevent a potential red zone injury
CSX employees can only use: - correct answer ✔CSX approved tools
Should you inspect CSX tools prior to use? - correct answer ✔Yes
Shop Machinery should be: - correct answer ✔outlined in a three inch yellow stripe.
What are the Mechanical Locomotive Crafts? - correct answer ✔Electricians
Machinists
Sheet Metal Workers
Boiler Makers
Utility Workers
Mechanical Car Craft - correct answer ✔Carman
Locomotive Electrical and Computer systems - correct answer ✔Inspections :
92 days
Annual
Network of shop Facilites - correct answer ✔Heavy Repair Shops
pass 2025/2026
What is the leading cause of injuries? - correct answer ✔Slip, trips and falls
Getting off equipment - correct answer ✔Stop at the bottom step or ladder rung to observe where you
are going to place yout feet.
Maintain 3 points of contact and do not let go of the handrails
Ensure both feet are firmly on the ground or floor
Employees less than 1 year - correct answer ✔Required to apply lime green reflective stripes to their
hard hats.
Walking on locomotive running boards - correct answer ✔Always use the handrails
What is the min. distance you must maintain when near standing cars? - correct answer ✔25 Feet (GS-
10)
What are common hazards in the mechanical department? - correct answer ✔Red Zones and Pinch
points
What zones should you be aware of when working in the mechanical department? - correct answer
✔Extended red zones
What is the required distance that must be kept when material is being handled by boom trucks and
backhoes? - correct answer ✔10 Feet
, What do overhead cranes create? - correct answer ✔Additional red zones
Mechanical employees are required : - correct answer ✔To use hand guard protection devieces for all
stricking tools in order to prevent a potential red zone injury
CSX employees can only use: - correct answer ✔CSX approved tools
Should you inspect CSX tools prior to use? - correct answer ✔Yes
Shop Machinery should be: - correct answer ✔outlined in a three inch yellow stripe.
What are the Mechanical Locomotive Crafts? - correct answer ✔Electricians
Machinists
Sheet Metal Workers
Boiler Makers
Utility Workers
Mechanical Car Craft - correct answer ✔Carman
Locomotive Electrical and Computer systems - correct answer ✔Inspections :
92 days
Annual
Network of shop Facilites - correct answer ✔Heavy Repair Shops
