FLORIDA PUMP OPERATOR EXAMS
COMPREHENSIVE EXAM SCRIPT 2026 SOLVED
QUESTIONS FULL SOLUTION
◉ Hub, shroud, vane and impeller are parts of? Answer: Centrifugal
pump
◉ Spiral section of the pump is called? Answer: Volute
◉ All apparatus's weighing over _____ must be equipped with an
auxiliary brake system. Answer: 36,000 lbs
◉ When training on a Tiller you might have to? Answer: Add a
detachable seat for the instructor
◉ Drivers may want to use ________________ during emergency
response? Answer: Excessive speed
◉ Most common elevating water devices are _____ tall? Answer: 50-
75ft
◉ Foam proportion?
,______ parts water & ____ parts foam Answer: 97 parts water, 3 parts
foam
◉ The D/O must ensure all occupants are wearing seatbelts.
Confirmation must be made _____________ before moving apparatus.
Answer: Verbally
◉ When is the break exhaust activated? Answer: When you remove
the pressure off of accelerator (foot off the gas pedal)
◉ What GPM's does PTO drive limit pump capacity too? Answer:
500 GPM's
◉ What is the typical length for intake hose used for hydrant
connection? Answer: 10-20ft
◉ How often should a pumper be tested? Answer: Annually
◉ What is the term for laying supply lines from the hydrant to the
fire scene? Answer: Forward lay
◉ What is the term for laying supply lines from the fire scene to the
hydrant? Answer: Reverse lay
,◉ An apparatus equipped with a fire pump, whose rated capacity is
less than 750 GPM is required to undergo the same certification test
as a Pumper over 750 GPM with the exception of? Answer: The
pumping engine overload test
◉ Engine pulls past or short of the hydrant to ________________ Answer:
allow the hose to curve.
◉ A counter clockwise turn on a connection between hydrants is to
Answer: prevent the pumper from forming kinks.
◉ ______________ use a pick-up tube that uses the pressure differential
from the stream passing through the venturi. Answer: Eductors
◉ Direct application is a method of applying Answer: Class A foam.
◉ If the operator during a backing operation feels unsafe he should
Answer: stop and then set the parking brake.
◉ In a water shuttle operation; nurse tendering and portable tanks
are operations located at __________________________________ Answer: the
dump site.
, ◉ Dual pumping uses Answer: one strong hydrant to supply two
pumpers.
◉ The least desirable hydrants are the ones on Answer: dead end
mains.
◉ ABS systems don't stop faster but Answer: greatly increase
controlled stops.
◉ Gears breaking and hard shifting are due to Answer: excessive
play.
◉ In engines over 2007 with DPS it is crucial to Answer: check
exhaust connections and flex pipe.
◉ The engine speed check is done with Answer: NO load.
◉ Steering wheel sensors along with accelerometers are also
equipped Answer: with stability control sensors.
◉ If operator fins damage he must first Answer: document it.
◉ Weather permitting the ______________ should be conducted outside.
Answer: function test
COMPREHENSIVE EXAM SCRIPT 2026 SOLVED
QUESTIONS FULL SOLUTION
◉ Hub, shroud, vane and impeller are parts of? Answer: Centrifugal
pump
◉ Spiral section of the pump is called? Answer: Volute
◉ All apparatus's weighing over _____ must be equipped with an
auxiliary brake system. Answer: 36,000 lbs
◉ When training on a Tiller you might have to? Answer: Add a
detachable seat for the instructor
◉ Drivers may want to use ________________ during emergency
response? Answer: Excessive speed
◉ Most common elevating water devices are _____ tall? Answer: 50-
75ft
◉ Foam proportion?
,______ parts water & ____ parts foam Answer: 97 parts water, 3 parts
foam
◉ The D/O must ensure all occupants are wearing seatbelts.
Confirmation must be made _____________ before moving apparatus.
Answer: Verbally
◉ When is the break exhaust activated? Answer: When you remove
the pressure off of accelerator (foot off the gas pedal)
◉ What GPM's does PTO drive limit pump capacity too? Answer:
500 GPM's
◉ What is the typical length for intake hose used for hydrant
connection? Answer: 10-20ft
◉ How often should a pumper be tested? Answer: Annually
◉ What is the term for laying supply lines from the hydrant to the
fire scene? Answer: Forward lay
◉ What is the term for laying supply lines from the fire scene to the
hydrant? Answer: Reverse lay
,◉ An apparatus equipped with a fire pump, whose rated capacity is
less than 750 GPM is required to undergo the same certification test
as a Pumper over 750 GPM with the exception of? Answer: The
pumping engine overload test
◉ Engine pulls past or short of the hydrant to ________________ Answer:
allow the hose to curve.
◉ A counter clockwise turn on a connection between hydrants is to
Answer: prevent the pumper from forming kinks.
◉ ______________ use a pick-up tube that uses the pressure differential
from the stream passing through the venturi. Answer: Eductors
◉ Direct application is a method of applying Answer: Class A foam.
◉ If the operator during a backing operation feels unsafe he should
Answer: stop and then set the parking brake.
◉ In a water shuttle operation; nurse tendering and portable tanks
are operations located at __________________________________ Answer: the
dump site.
, ◉ Dual pumping uses Answer: one strong hydrant to supply two
pumpers.
◉ The least desirable hydrants are the ones on Answer: dead end
mains.
◉ ABS systems don't stop faster but Answer: greatly increase
controlled stops.
◉ Gears breaking and hard shifting are due to Answer: excessive
play.
◉ In engines over 2007 with DPS it is crucial to Answer: check
exhaust connections and flex pipe.
◉ The engine speed check is done with Answer: NO load.
◉ Steering wheel sensors along with accelerometers are also
equipped Answer: with stability control sensors.
◉ If operator fins damage he must first Answer: document it.
◉ Weather permitting the ______________ should be conducted outside.
Answer: function test
