ATT WEEK 6 EXAM SCRIPT STUDY GUIDE 2026
FULL SOLUTION A+
◉ What is the total phase shift in an RC Phase shift oscillator?
Answer: 360 degrees.
Q1 is a common emitter amplifier that produces a 180 degree phase
shift. Each RC network produces a phase shift as well by 60 degree
each.
◉ How is frequency determined with the sawtooth oscillator?
Answer: The frequency of the output is determined by the frequency
of the input.
◉ What is the purpose of a blocking oscillator? Answer: They change
DC into short, rectangular pulses that can be used as timing pulses
to trigger other circuits.
◉ Blocking Oscillator Answer: Any oscillator that cuts off its own
oscillations at a predetermined time.
◉ Transconductance (gm) Answer: The amount of control that the
input voltage has over the output current.
Gm= Ioutput/Einput
, ◉ All FET biasing techniques accomplish two things: Answer: (1.)
Place a positive voltage on the drain to establish current flow.
(2.) Reverse bias the source to gate PN junction to control current
flow.
◉ Which is the most widely used FET? Answer: Common Source
◉ What is Calculated Av? Answer: Gm*Rd
◉ What are common gate FET normally used as? Answer: Switch
◉ What are Common Source and Common Drain FETs normally used
for? Answer: Amplifiers
◉ Forward biased measurements indicate what? Answer: Normal
resistance reading is low. A high reading indicates an Open FET.
◉ Reversed biased measurements indicate what? Answer: Normal
resistance measurement is high. A low reading indicates a shorted
FET.
FULL SOLUTION A+
◉ What is the total phase shift in an RC Phase shift oscillator?
Answer: 360 degrees.
Q1 is a common emitter amplifier that produces a 180 degree phase
shift. Each RC network produces a phase shift as well by 60 degree
each.
◉ How is frequency determined with the sawtooth oscillator?
Answer: The frequency of the output is determined by the frequency
of the input.
◉ What is the purpose of a blocking oscillator? Answer: They change
DC into short, rectangular pulses that can be used as timing pulses
to trigger other circuits.
◉ Blocking Oscillator Answer: Any oscillator that cuts off its own
oscillations at a predetermined time.
◉ Transconductance (gm) Answer: The amount of control that the
input voltage has over the output current.
Gm= Ioutput/Einput
, ◉ All FET biasing techniques accomplish two things: Answer: (1.)
Place a positive voltage on the drain to establish current flow.
(2.) Reverse bias the source to gate PN junction to control current
flow.
◉ Which is the most widely used FET? Answer: Common Source
◉ What is Calculated Av? Answer: Gm*Rd
◉ What are common gate FET normally used as? Answer: Switch
◉ What are Common Source and Common Drain FETs normally used
for? Answer: Amplifiers
◉ Forward biased measurements indicate what? Answer: Normal
resistance reading is low. A high reading indicates an Open FET.
◉ Reversed biased measurements indicate what? Answer: Normal
resistance measurement is high. A low reading indicates a shorted
FET.