Cts Assessment Materials 2026 Verified Solutions Graded A+

CTS ASSESSMENT MATERIALS 2026
VERIFIED SOLUTIONS GRADED A+

◍ When making a 2 inch hole in a piece of thin sheet metal, what is
the BEST tool to use.
a. Stepped drill bit
b. Carbide drill bit
c. Metal punch
d. Hole saw. Answer: c. Metal punch


◍ Heat dissipated by equipment in an AV rack is measured in:
a. Degrees
b. Coulombs
c. BTU/H
d. Watts. Answer: c. BTU/H


◍ Where do you place the wireless microphone receiver antenna in a
rack assembly?
a. Close to the transmitter
b. Inside the room
c. Outside the rack
d. Inside the rack. Answer: c. Outside the rack

, ◍ When mounting equipment to a concrete substructure, which
fastener is the most likely to be used?
a. Toggle Bolt/Spring Toggle
b. Self tapping screw
c.Drop in Anchor
d.Molly Bolt/hollow wall anchor. Answer: c.Drop in Anchor


◍ What type of termination technique is used for a solid conductor
RJ45 connector?
a. Solder
b. Crimp
c. Insulation displacement
d. Compression. Answer: c. Insulation displacement


◍ A network cabling test that verifies a signal can travel from one end
of the cable to the other is called a(n) ___?
a. Impedance
b. Continuity
c. Insulation
d. Polarity. Answer: b. Continuity


◍ What method can a technician use onsite to verify that the AV
device is set to the proper IP address?
a. Connect directly to the CPU using an XLR connector and the Ping
program