Second Class Fireman Questions With Complete Solutions
"nominal pipe size" in terms of saftey valves? Correct Answers
the inlet size of the valve
a high pressure boiler must have _______ pressure controls
Correct Answers operating recycle and a high pressure limit
control
a lwfco must be installed where in relation to the water gage
glass? Correct Answers the primary lwfco must be installed
about 2 inches above the bottom of the glass. The secondary
must function prior to the water dropping out of sight in the
glass.
average btu values of Coal, Oil, and natural gas. Correct
Answers coal-14,000/lb
#6 oil-18,500/lb
gas- 1000/cu ft
downcomer tubes are found in _____ boilers Correct Answers
water tube
During the start up of a turbine are the drains open ? Correct
Answers Yes, the turbine casing drains and any steam line
drains should be open until properly warmed up.
How are the main steam and reheat steam lines pitched leaving
the boiler? Correct Answers They could be pitched away from
the boiler.
, How do you convert #/hr into BHP? Correct Answers Divide by
34.5
How do you determine the hp of a steam turbine for licensing?
Correct Answers By the external diameter of the steam supply
pipe. Chapter 146.
How do you find boiler HP given the Btu's? Correct Answers
Btu input divided by 41,840 or Btu output divided by 33,475.
how does air temp affect the operation of a combustion turbine
Correct Answers the cooler the air temp the more air can be
forced into the turbine increasing the power output.
how long can a plant operate without a EIC? Correct Answers 7
days.
How many Btu's are there in a barrel of #6 fuel oil? Correct
Answers There is approximately 150,000 Btu/gal and 42 gal per
barrel, therefore:150,000x42=6,300,000 Btu/bbl.
How many btu's in a dekatherm? Correct Answers 1,000,000
how many btus in a gallon of #6 oil Correct Answers
approximately 150,000
how many gallons of fuel oil are in a barrel Correct Answers 42
how many safety valves are required on a boiler Correct
Answers at least one set at or below mawp. if over 500 sqft of
bare tube heating surface, then at least 2 are required.
"nominal pipe size" in terms of saftey valves? Correct Answers
the inlet size of the valve
a high pressure boiler must have _______ pressure controls
Correct Answers operating recycle and a high pressure limit
control
a lwfco must be installed where in relation to the water gage
glass? Correct Answers the primary lwfco must be installed
about 2 inches above the bottom of the glass. The secondary
must function prior to the water dropping out of sight in the
glass.
average btu values of Coal, Oil, and natural gas. Correct
Answers coal-14,000/lb
#6 oil-18,500/lb
gas- 1000/cu ft
downcomer tubes are found in _____ boilers Correct Answers
water tube
During the start up of a turbine are the drains open ? Correct
Answers Yes, the turbine casing drains and any steam line
drains should be open until properly warmed up.
How are the main steam and reheat steam lines pitched leaving
the boiler? Correct Answers They could be pitched away from
the boiler.
, How do you convert #/hr into BHP? Correct Answers Divide by
34.5
How do you determine the hp of a steam turbine for licensing?
Correct Answers By the external diameter of the steam supply
pipe. Chapter 146.
How do you find boiler HP given the Btu's? Correct Answers
Btu input divided by 41,840 or Btu output divided by 33,475.
how does air temp affect the operation of a combustion turbine
Correct Answers the cooler the air temp the more air can be
forced into the turbine increasing the power output.
how long can a plant operate without a EIC? Correct Answers 7
days.
How many Btu's are there in a barrel of #6 fuel oil? Correct
Answers There is approximately 150,000 Btu/gal and 42 gal per
barrel, therefore:150,000x42=6,300,000 Btu/bbl.
How many btu's in a dekatherm? Correct Answers 1,000,000
how many btus in a gallon of #6 oil Correct Answers
approximately 150,000
how many gallons of fuel oil are in a barrel Correct Answers 42
how many safety valves are required on a boiler Correct
Answers at least one set at or below mawp. if over 500 sqft of
bare tube heating surface, then at least 2 are required.