NEIEP 200 Final Assessment (Latest 2025 / 2026 Update) Questions and Verified Answers 100% Correct {Grade A}

NEIEP 200 Final Assessment (Latest 2025 / 2026 Update) Questions and Verified Answers 100% Correct {Grade A} When should the relief valve seal be changed? -correct answer After each adjustment Which of the following statements is NOT true of pressure gauges? -correct answer Gauges should be permanently installed in the hydraulic system The pressure with full load in the up direction at rated speed defines which of the following? -correct answer Working pressure Which of the following is the term for maximum pressure which read at the machine that is permitted into the jack? -correct answer Relief pressure Which of the folloing pressures must be kept below 150% of working pressure? -correct answer Relief Pressure Which of the following pressures is acceptable for a relief valve setting on a car with a 420 psi -correct answer 490 How is a 15 min leak test performed? -correct answer Empty car at a landing At what intervals are normal and final stopping devices required to be tested? -correct answer Annually At what point of travel should the door pressure be measured? -correct answer Within the center 1/3 of travel What is the maximum closing stalled door pressure allowed by A 17.1 code? -correct answer 30 lbs When testing a low oil timer what must the results be? -correct answer The car must return to the lowest landing. The door must open and re-ose within 15 seconds and then remove itself from service with the inside door open button active. How long must relief pressure be maintained on a flexible line and couplings during testing? -correct answer 30 seconds