J-STD-001 Exam comprehensive questions |
FREQUENTLY MOST TESTED QUESTIONS AND
VERIFIED SOLUTIONS/GET IT 100% ACCURATE!!
2025!!
Save
Practice questions for this set
Learn 1 /7 Study with Learn
When a wire is wrapped more than 360 and remains in contact with the
terminal
Choose an answer
Who is responsible for identifying
1 What is wire over wrap? 2
the assembly class?
Manufacturer shall verify ESD is
A documented process control
3 adequate when humidity falls below 4
system shall be implemented for:
30% for:
, Don't know?
Terms in this set (87)
Who is responsible for User
identifying the assembly
class?
A condition that may affect the form, fit, or function of
What is a defect?
the item in the end use environment
Hardware found to not [D1D2D3]
conform to the
requirements of the
standard shall be
classified as defects and
dispositioned for:
There shall be no broken [D1D2D3]
strands for wires used at a
potential of 6kV or
greater:
A documented process [N1N2D3]
control system shall be
implemented for:
The contract shall take [D1D2D3]
precedence over this
standard for:
When a wire is wrapped more than 360 and crosses
What is wire overlap?
over itself
When a wire is wrapped more than 360 and remains in
What is wire over wrap?
contact with the terminal
Manufacturers shall [N1D2D3]
perform 100% inspection
unless sampling
inspection is defined for:
FREQUENTLY MOST TESTED QUESTIONS AND
VERIFIED SOLUTIONS/GET IT 100% ACCURATE!!
2025!!
Save
Practice questions for this set
Learn 1 /7 Study with Learn
When a wire is wrapped more than 360 and remains in contact with the
terminal
Choose an answer
Who is responsible for identifying
1 What is wire over wrap? 2
the assembly class?
Manufacturer shall verify ESD is
A documented process control
3 adequate when humidity falls below 4
system shall be implemented for:
30% for:
, Don't know?
Terms in this set (87)
Who is responsible for User
identifying the assembly
class?
A condition that may affect the form, fit, or function of
What is a defect?
the item in the end use environment
Hardware found to not [D1D2D3]
conform to the
requirements of the
standard shall be
classified as defects and
dispositioned for:
There shall be no broken [D1D2D3]
strands for wires used at a
potential of 6kV or
greater:
A documented process [N1N2D3]
control system shall be
implemented for:
The contract shall take [D1D2D3]
precedence over this
standard for:
When a wire is wrapped more than 360 and crosses
What is wire overlap?
over itself
When a wire is wrapped more than 360 and remains in
What is wire over wrap?
contact with the terminal
Manufacturers shall [N1D2D3]
perform 100% inspection
unless sampling
inspection is defined for:
