answers with solutions
A new security appliance was installed on a network as part of a
managed service deployment. The vendor controls the appliance, and
the IT team cannot log in or configure it. The IT team is concerned about
the appliance receiving the necessary updates. Whi ch of the following
mitigations should be performed to minimize the concern for the
appliance and updates?
Vulnerability scanning
A cybersecurity analyst is conducting a port scan of 192.168.1.45 using
nmap. During the scan, the analyst found numerous ports open, and
nmap could not determine the Operating System version of the system
installed at 192.168.1.45. The analyst asks you to look over the results of
their nmap scan results:
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
Starting NMAP 7.60 at 2020-06-12 21:23:15
NMAP scan report for 192.168.1.45
Host is up (0.78s latency).
Not shown: 992 closed ports
PORT STATE SERVICE
21/tcp open ftp
23/tcp open telnet
25/tcp open smtp
80/tcp open http
139/tcp open netbios-ssn
515/tcp open
631/tcp open ipp
9100/tcp open
MAC Address: 00:0C:29:18:6B:DB
, -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
Which of the following operating systems is most likely used by the
host?
Networked printer
3 multiple choice options
Which of the following technologies could be used to ensure that users
who log in to a network are physically in the same building as the
network they are attempting to authenticate on? (SELECT TWO)
Part I
NAC
2 multiple choice options
Which of the following technologies could be used to ensure that users
who log in to a network are physically in the same building as the
network they are attempting to authenticate on? (SELECT TWO)
Part II
GPS location
2 multiple choice options
Which of the following authentication protocols was developed by Cisco
to provide authentication, authorization, and accounting services?
TACACS+
3 multiple choice options
Dion Training's security team recently discovered a bug in their
software's code. The development team released a software patch to
remove the vulnerability caused by the bug. What type of test should a
software tester perform on the application to ensure that it is still
functioning properly after the patch is installed?