Ironworkers Assignment Sheet 8.1 Questions and Answers | Latest Version | 2024/2025 | Correct & Verified

Ironworkers Assignment Sheet 8.1 Questions and Answers | Latest Version | 2024/2025 | Correct & Verified What is the primary function of a spud wrench in ironworking? A. To cut steel beams B. To align holes for bolts C. To tighten chain links D. To hold welding rods What should be checked before lifting a structural steel beam? A. The condition of slings and rigging equipment B. The paint on the beam C. The weather forecast D. The beam’s length What is the purpose of a bolt-up connection in steel construction? A. To provide temporary support B. To securely join two steel components 2 C. To lift beams into position D. To store tools on-site When aligning holes in steel members, what tool is most commonly used? A. A hammer B. A drift pin C. A screwdriver D. A wrench What is the safe angle for a ladder used in steel erection? A. Approximately 75 degrees B. 60 degrees C. 90 degrees D. 45 degrees Why is it important to use a tagline when hoisting steel components? A. To control the load and prevent swinging B. To increase lifting speed 3 C. To stabilize the crane D. To mark the lifting area What does the term “plumb” mean in steel construction? A. Vertical alignment of a structure B. Horizontal alignment of a structure C. Strength of a joint D. Weight of a beam When using fall protection, what is the minimum breaking strength for a lifeline? A. 2,000 pounds B. 5,000 pounds C. 10,000 pounds D. 15,000 pounds What should be done if a bolt does not fit through a hole during assembly? A. Use a reamer to adjust the hole size B. Force the bolt through with a hammer 4 C. Replace the bolt with a smaller size D. Weld the components instead Why is pre-heating steel sometimes necessary before welding? A. To reduce the risk of cracking during welding B. To melt the steel faster C. To prevent rust from forming D. To align the pieces better What is the primary function of a beam clamp? A. To secure beams temporarily during construction B. To lift heavy beams C. To hold bolts in place