NCCER Electrical 1 Module 10-
Questions & Answers
Blue Prints Correct Ans-An exact copy of reproduction of an original drawing
Floor plan Correct Ans-As viewed from above
Site plan Correct Ans-Location of building on the property
Surveys show Correct Ans-All property lines, existing public utilities and their location on or
near the property
Elevation drawings show Correct Ans-The exterior face of the building
Floor plans are in Correct Ans-2 dimension, length and width
Topographic survey shows Correct Ans-Property lines, contour lines, notes and symbols
Sectional view Correct Ans-Is a cutaway view that shows the inside of the building
, Title block Correct Ans-A table located in the bottom right-hand corner of an engineering
drawing that identifies, in an organized way, all of the necessary information that is not given on
the drawing itself. Also referred to as a title strip.
Revision Block Correct Ans-Shows modifications or redrawn drawings
Architectural scale Correct Ans-1/16" = 1', 1/8" = 1' 1/4" = 1
Engineer scale measurements Correct Ans-1"=10 units through 1"=100 units
Metric scale 1:1 to 1:100 Correct Ans-Millimeters are used
Metric scale 1:200 to 1:2000 Correct Ans-Meter is used
CAD Correct Ans-Computer aided design
Masterformat Correct Ans-Most common used writing format
Division 26 is Correct Ans-Electrical
Division 27 is Correct Ans-Communications
Questions & Answers
Blue Prints Correct Ans-An exact copy of reproduction of an original drawing
Floor plan Correct Ans-As viewed from above
Site plan Correct Ans-Location of building on the property
Surveys show Correct Ans-All property lines, existing public utilities and their location on or
near the property
Elevation drawings show Correct Ans-The exterior face of the building
Floor plans are in Correct Ans-2 dimension, length and width
Topographic survey shows Correct Ans-Property lines, contour lines, notes and symbols
Sectional view Correct Ans-Is a cutaway view that shows the inside of the building
, Title block Correct Ans-A table located in the bottom right-hand corner of an engineering
drawing that identifies, in an organized way, all of the necessary information that is not given on
the drawing itself. Also referred to as a title strip.
Revision Block Correct Ans-Shows modifications or redrawn drawings
Architectural scale Correct Ans-1/16" = 1', 1/8" = 1' 1/4" = 1
Engineer scale measurements Correct Ans-1"=10 units through 1"=100 units
Metric scale 1:1 to 1:100 Correct Ans-Millimeters are used
Metric scale 1:200 to 1:2000 Correct Ans-Meter is used
CAD Correct Ans-Computer aided design
Masterformat Correct Ans-Most common used writing format
Division 26 is Correct Ans-Electrical
Division 27 is Correct Ans-Communications
