Plumbing Book Year 2 Module 5 Questions and Answers | Latest Version | 2024/2025 | Correct & Verified

Plumbing Book Year 2 Module 5 Questions and Answers | Latest Version | 2024/2025 | Correct & Verified What is the primary purpose of a water pressure regulator? To control and maintain a consistent water pressure within the plumbing system What does the term "backflow" refer to in plumbing? The unwanted reverse flow of water or chemicals into the potable water supply What is the function of a check valve? To allow fluid to flow in only one direction and prevent backflow What is a trap used for in plumbing? To prevent sewer gases from entering the living spaces by holding a small amount of water What is the difference between PVC and CPVC pipe? PVC is used for cold water systems, while CPVC is used for hot and cold water systems 2 What is the purpose of a vent pipe in a plumbing system? To allow air to enter the system and equalize pressure, preventing water seal loss in traps What is the role of a sump pump? To remove water that accumulates in a sump basin, typically in basements What is a sanitary tee used for in plumbing? To connect horizontal and vertical drain lines, allowing for efficient drainage What is the purpose of a hose bibb in plumbing? To provide an outdoor water faucet for garden hoses or other water needs What is a DWV system in plumbing? A system designed to handle drains, waste, and venting of wastewater What does the term "fixture unit" refer to in plumbing? A standardized measurement used to estimate the water demand for plumbing fixtures 3 What is the purpose of a pressure relief valve on a water heater? To release pressure when it exceeds a safe level, preventing damage or explosion What is a Y-strainer used for in plumbing? To filter out debris and particles from the water flow to protect plumbing components What is the function of a manifold in plumbing systems? To distribute water to multiple branches or fixtures from a single water source What is the purpose of using solder in copper pipe connections? To create a watertight bond between copper pipes by melting the solder at the joint What is the typical installation location for a water meter? Near where the water service line enters the building, often in the basement or outside What is the purpose of a drip leg in a gas line? To collect moisture or debris before they enter the appliance or system 4 What does "capping" a pipe mean in plumbing? To seal the end of a pipe with a cap to stop water flow What is the purpose of an air gap in plumbing systems? To prevent backflow by providing a physical