NCCER Carpentry Module 5 Questions and Answers | Latest Version | 2024/2025 | Graded A+

NCCER Carpentry Module 5 Questions and Answers | Latest Version | 2024/2025 | Graded A+ What is a plumb line used for? To determine vertical alignment What is a header in framing? A horizontal beam placed over an opening like a door or window for support What is the main function of a joist? To support floors or ceilings What is the purpose of a pilot hole? To guide screws or nails and prevent wood from splitting What is a miter cut? An angled cut made across the face of a piece of wood 2 What is the function of a chalk line in carpentry? To mark straight lines on surfaces What is the importance of measuring twice before cutting? To ensure accuracy and avoid material waste What type of saw is best for cutting curves in wood? A jigsaw What tool is used to ensure a board is cut squarely? A miter box or miter saw What does the term "face grain" refer to in wood? The visible surface grain pattern of a wood board What is the purpose of sanding in carpentry? To smooth the wood surface and prepare it for finishing 3 What is a nail set used for? To drive the head of a nail below the surface of the wood What is a butt joint in woodworking? A joint where two pieces of wood are joined end to end What is a dado cut? A groove cut into wood to receive another piece What is the function of a framing hammer? To drive nails and assist with framing tasks What is the purpose of wood glue? To bond wood pieces together for added strength What is a rabbet joint? A notch cut along the edge of a board