NEIEP 800 Final New Update Actual Test with complete solution

Hydro elevators in low rise applications do not need an _____ _____ room. - Answer-overhead machine Some advantages of hydros are lower equipment and building construction costs because the load of a hydro is carried to the _____ where as the load of a traction car is carried by the _____ _____. - Answerground, building structure When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove the drill stem and bit and use a _____ _____. - Answer-Spider Bob To plumb the hole, a spider bob is attached to a length of piano wire suspended from as near as possible to the top of the _____ or from a fixed point on the drill rig. - Answer-Hoistway When welding a joint, lay _____ inch tack welds _____ degrees apart, shift it 90 degrees and lay two more 1 inch tack welds 180 degrees apart. - Answer-1, 180 On power units having the motor beneath the tank, the pump may be either _____ driven or _____ coupled. - Answer-belt, direct The purpose of the _____/_____ is to silence the effect of any pulsations in the pump output and should be as close to the pump as possible. - Answer-silencer, muffler On Bolsters/Bolster Assembly, the plunger is fastened to the _____ _____ which is then mounted to the center of the Bolster Assembly. - Answer-platen plate With wye-delta, reduced current starting is accomplished without the need for _____. - Answer-resistors _____ run buttons should run the platform and sling at leveling speeds only. - Answer-Temporary A _____ _____ consists of a piston held closed by an adjustable spring and must open at a certain pressure to prevent any further increase in pressure. - Answer-relief valveA _____ lowering valve allows the car to be lowered at a speed not exceeding 20fpm in case of power failure. - Answer-manual As the oil temperature changes, the _____ will change as well and will effect the performance, more specifically, the leveling and approach of the elevator. - Answer-viscosity Be sure wellways are properly _____ to avoid accidental injury to you, your team or anyone working outside of our industry. - Answer-barricaded Barricades around the wellway must be _____ inches high and be capable of withstanding a _____lb force. - Answer-42, 200 A _____ protects you if you come in contact with a hot wire or component and then come in contact with ground. It opens the circuit and diverts the supplied current to ground. - Answer-GFCI A _____ _____ is useful for horizontal (side-to-side) pulling of the truss while being lowered into the wellway. - Answer-lever hoist Code specifies the use of anti-slide devices if the outer edge of the deck is greater than _____ inches from the center line of the handrail. - Answer-12 (True/False) Anti-slide devices must be less than 3/4" in height, have no sharp corners or edges and fastened to the deck no closer than 4 inches from the handrail and spaced no greater than 6ft apart. - Answer-True Sometimes referred to as sag switches, _____ _____ switches are located within the step band of both upper and lower truss assemblies and function to prevent a step that is sagging by more than _____ inch. - Answer-step level, 1/8 Per code, an installed escalator can exceed the 30 degree angle of inclination by _____ degree. - Answer- 1When it comes to moving walks code states that the angle of inclination of the truss from the horizontal shall not exceed _____ degrees within _____ ft of the entrance or exits and shall not exceed _____ degrees at any point. - Answer-3, 3, 12 Belted walkways use a tensioning device at the tail end to maintain the proper tension on the treadway belt and is normally maintained at _____ lbs. - Answer-3000