Table Saw Safety and Operation Test (2023/2024) Already Passed

Table Saw Safety and Operation Test (2023/2024) Already Passed What should be done with articles of clothing such as ties, coats and long sleeves when operating the Table Saw? Remove or fasten them out of the way. Which of the following items should NOT be worn when operating the Table Saw? Rings,Gloves, Bracelets (All of these!) Personal protective equipment which SHOULD BE worn when operating the Table Saw is/are ... Ear protectors, safety glasses ("both b and c) When setting the Table Saw up for a job, the saw blade should be checked for ... Cracks and missing teeth. The arbor nut on a Table Saw is tightened only when ... The electrical service is disconnected at the circuit breaker. To prevent slipping or falling when using the Table Saw ... Do not over-reach when feeding material through the saw. When sawing with the Table Saw, which of the following would NOT be a safe practice? Stand in line with the saw blade. After a cut has been completed, what should the operator do before leaving the Table Saw? Make sure the saw blade has stopped turning. When making a rip or cross cut, the saw blade should extend no more than ________ inches above the stock being cut. 1/4 or 1/8 When bevel or chamfer cuts are made, the hands of the operator should be .... Opposite side from which the blade is tilted. Which type of stock should never be ripped on the Table Saw? Round stock. Which of the following operations require the use of a push stick on the Table Saw? Ripping narrow materials. Which Table Saw accessory gives width settings for the rip fence? Front rail. A push stick must be used if material is less than _______ inches in width. 6 The purpose of the off-bearer, in the Table Saw operation, is to ... Support the stock as it is pushed through the saw. When ripping warped lumber the bow should be turned ... Down The maximum distance the rip fence can safely be set from the saw blade is ... The distance measured when the carriage is flush with the end of the front rail. The accessory used when crosscutting on the Table Saw is the ... Miter head. When crosscutting, most Table Saw operators prefer to work on the ________ side of the saw blade. Left The miter head gauge is calibrated in ... Degrees The miter head and right hand table slot are recommended for use when ... Compound bevel crosscuts are to be made. When stock is held loosely against the miter head one may experience ... Poor cuts, binding of the blade, material vibration (All of these) When long materials are crosscut on the Table Saw the operator needs ... Auxiliary support.