• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 3 out of 17 pages
Exam (elaborations)

Mechanical Engineering I.C Engines Important MCQ

Document preview thumbnail
Preview 3 out of 17 pages

Mechanical Engineering I.C Engines Important MCQ

Content preview

WWW.ALLEXAMREVIEW.COM ALL EXAM REVIEW ADDA


Mechanical Engineering I.C Engines Important MCQ PDF

1. The working cycle in case of four stroke engine is completed in following number of
revolutions of crankshaft
(a) 1/2
(b) 1
(c) 2
(d) 4
(e) 8.
Ans: c

2. In a diesel engine, the fuel is ignited by
(a) spark
(b) injected fuel
(c) heat resulting from compressing air that is supplied for combustion
(d) ignition
(e) combustion chamber.
Ans: c

3. Scavenging air in diesel engine means
(a) air used for combustion sent under pres-sure
(b) forced air for cooling cylinder
(c) burnt air containing products of combustion
(d) air used for forcing burnt gases out of engine’s cylinder during the exhaust period
(e) air fuel mixture.
Ans: d

4. Supercharging is the process of
(a) supplying the intake of an engine with air at a density greater than the density of the
surrounding atmosphere
(b) providing forced cooling air
(c) injecting excess fuel for raising more load
(d) supplying compressed air to remove combustion products fully
(e) raising exhaust pressure.
Ans: a

5. Does the supply of scavenging air at a density greater than that of atmosphere mean engine is
supercharged ?
(a) yes
(b) no
(c) to some extent
(d) unpredictable
(e) depends on other factors.
Ans: b

6. The ratio of indicated thermal efficiency to the corresponding air standard cycle efficiency is
called
(a) net efficiency


Page |1

,WWW.ALLEXAMREVIEW.COM ALL EXAM REVIEW ADDA

(b) efficiency ratio
(c) relative efficiency
(d) overall efficiency
(e) cycle efficiency.
Ans: c

7. Compression ratio of LC. engines is
(a) the ratio of volumes of air in cylinder before compression stroke and after compression stroke
(b) volume displaced by piston per stroke and clearance volume in cylinder
(c) ratio of pressure after compression and before compression
(d) swept volume/cylinder volume
(e) cylinder volume/swept volume.
Ans: a

8. The air standard efficiency of an Otto cycle compared to diesel cycle for the given compression
ratio is
(a) same
(b) less
(c) more
(d) more or less depending on power rating
(e) unpredictable.
Ans: c

9. The calorific value of gaseous fuels is expressed in terms of
(a) kcal
(b) kcal/kg
(c) kcal/m2
(d) kcal/n?
(e) all of the above.
Ans: d

10. If the intake air temperature of I.C. engine increases, its efficiency will
(a) increase
(b) decrease
(c) remain same
(d) unpredictable
(e) depend on other factors.
Ans: b

12. All heat engines utilize
(a) low heat value of oil
(b) high heat value of oil
(c) net claorific value of oil
(d) calorific value of fuel
(e) all of the above.
Ans: a




Page |2

, WWW.ALLEXAMREVIEW.COM ALL EXAM REVIEW ADDA

13. An engine indicator is used to determine the following
(a) speed
(b) temperature
(c) volume of cylinder
(d) m.e.p. and I.H.P.
(e) BHP.
Ans: d

14. Fuel oil consumption guarantees for I .C. engine are usually based on
(a) low heat value of oil
(b) high heat value of oil
(c) net calorific value of oil
(d) calorific value of fuel
(e) all of the above.
Ans: b

17. If the compression ratio of an engine working on Otto cycle is increased from 5 to 7, the
%age increase in efficiency will be
(a) 2%
(b) 4%
(c) 8%
(d) 14%
(e) 27%.
Ans: d

18. In case of gas turbines, the gaseous fuel consumption guarantees are based on
(a) high heat value
(b) low heat value
(c) net calorific value
(d) middle heat value
(e) calorific value.
Ans: b

19. In a typical medium speed 4-stroke cycle diesel engine the inlet valve
(a) opens at 20° before top dead center and closes at 35° after the bottom dead center
(b) opens at top dead center and closes at bottom dead center
(c) opens at 10° after top dead center and closes 20° before the bottom dead center
(d) may open or close anywhere
(e) remains open for 200°.
Ans: a

20. The pressure and temperature at the end of compression stroke in a petrol engine are of the
order of
(a) 4 – 6 kg/cm2 and 200 – 250°C
(b) 6 – 12 kg/cm2 and 250 – 350°C
(c) 12 – 20 kg/cm2 and 350 – 450°C
(d) 20 – 30 kg/cm2 and 450 – 500°C
(e) 30 – 40 kg/cm2 and 500 – 700°C.
Ans: b


Page |3

Document information

Study
Uploaded on
July 29, 2025
Number of pages
17
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers
CA$13.98

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
TopGradeSolutions
4.9
(175)
Sold
123
Followers
10
Items
13706
Last sold
2 weeks ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions