TECHNICIAN (LEVEL 11) EXAM |
GUARANTEED PASS!!
What is the primary function of the IMAS? - Accurate Answers✔✔✔
Safety Education
IMSA Stands for - Accurate Answers✔✔✔ International Municipal
Signal Association
Which of the following is NOT an IMSA certification? - Accurate
Answers✔✔✔ Traffic Signal Level III Bridge Technician
Which of the following are potential safety hazards? - Accurate
Answers✔✔✔ overhead and underground power, gas, aerial lift
equipment. Tra
What are the sections of a ramp mete signal - Accurate Answers✔✔✔
Circular red, circular green
PPE stands for - Accurate Answers✔✔✔ Personal Protective Equipment
A work zone supervisor is responsible for which of the following tasks: -
Accurate Answers✔✔✔ Ensure advance warning devices have not been
removed or relocated.
,Which of the following is NOT a sentence type in the MUTCD?
Standards; requirement that have to be followed.
Guidance; recommendations that are to be followed unless there I good
reason not to.
Objectives; reasons behind the standards and guidance.
Support; additional information to clarify the standards and guidance. -
Accurate Answers✔✔✔ Objectives; reasons behind the standards and
guidance
Which of the following is an example configuration fo an Emergency -
Vehicle Traffic Control Signals? - Accurate Answers✔✔✔ Thee section
traffic signal with circular red, circular yellow, and smaller circular
yellow indications.
The following phases are typically assigned to the major-street through
movements: - Accurate Answers✔✔✔ 2 and 6
There green interval is made up of which three components? - Accurate
Answers✔✔✔ Minimum green, passage time, maximum green
What are the three typical types of recall features of a traffic signal
controller? - Accurate Answers✔✔✔ Minimum, Maximum, Pedestrian
In a coordination plan, what is the number of seconds given to each
phase at the intersection? - Accurate Answers✔✔✔ split
, Which of the following traffic signal coordination methods is typically
the least expensive? - Accurate Answers✔✔✔ Time-Based Coordination
Which of the following is a definition for cycle length? - Accurate
Answers✔✔✔ The elapsed time between the start of a specific display
until that display comes up again.
Which of the following is a characteristic of sequential phases? -
Accurate Answers✔✔✔ they cannot occur at the same time.
Which of th following is a definition for initial green time - Accurate
Answers✔✔✔ Minimum time that that the green indication myst be
displayed
The only point in the cycle of a coordinated traffic signal controller
where the major street phase is allowed to end is called - Accurate
Answers✔✔✔ Yield point
Which of ht following is NOT a common mode of operation for timing
plans in a signal system? - Accurate Answers✔✔✔ Traffic Related
Two common terms to describe traffic signal supports and signal heads
are - Accurate Answers✔✔✔ rigid and free-swinging