Fire Inspector 2 Questions with 100% Correct Solutions (GRADED A+)

A code is: - A legal requirement of a building feature or operating feature at a certain location A standard is: - A set of specifications or requirements that is considered industry best practice and meets a minimum level of performance guidelines The most important tool the fire inspector possesses is: - Knowledge Any non-compliance (code violation) that has been noticed during the fire inspection: - Must be documented in the written report of the inspection One of the things that a Fire Inspector II could be expected to do that a Fire Inspector I would not, is to: - Process a permit application A permit to use a chemical during a manufacturing process is an example of a(n): - Hazardous materials use permit Which of the following individuals may have full police powers to investigate and arrest suspected arsonist and people causing false alarms? - Fire investigator To ensure that an installation or construction is safe to be occupied, a fire inspector uses: - Both prescriptive code and performance-based code The International Code Council is an example of a(n): - Model code organization The principles that a fire inspector should follow during an inspection are dictated by: - Ethics In the process of adopting a new or modified code or standard, the correct sequence of steps would be: - Identification of need, Review by elected officials, public hearing, adoption of code into statute Which of the following positions describes a fire inspector who works within a fire department and who may respond to the fire scenes for investigative purposes? - Fire Marshal Type II building is: - Same as Type I but with less fire resistance Dry wall is considered: - Limited-Combustible Masonry exterior bearing walls are usually found in: - Type III and IV construction What can be said about steel members? - They can melt in a severe fire Part of the building's weight and the building's content are supported by a: - Load-bearing wall The most fire-resistive category of building construction is: - Type I Annealed glass is known as: - Single-pane glass The most common building material is: - Wood Pyrolysis refers to: - Decomposition without combustion The most common type of construction used today is: - Type V Which of the following statements is true about gypsum board? - It is a good insulator and noncombustible Trusses are used: - For both floors and roofs In Type III (ordinary) construction, the fuel load in a fire is the: - Combustible building materials and contents of the building A barn used to shelter animals would be considered a(n): - Storage occupancy Personal care services are provided in a(n): - Residential board and care occupancy Possible panic hazard in the event of emergency must be considered when inspecting a(n): - Assembly occupancy Open structures, piers, vehicles, and tents would all be considered: - Special structures Deliberately circuitous egress paths would be expected to be found in a(n): - Mercantile occupancy A building with sleeping accommodations for more than 16 people would be classified as a(n): - Hotel in a detention and correctional occupancy, Use Condition III corresponds to: - Zoned Impeded Egress One and two family dwelling occupancies contain: - No more than two dwelling units with independent cooking and bathroom facilities Doctors' offices, city halls, college classrooms, and air traffic control towers would all be considered: - Business occupancies There is a storage room where wooden pallets are stored. A fire in this room would be which class of fire? - Class A You find an alcove where liquefied petroleum cylinders are being stored. This practice could present a hazard because: - If the tanks are involved in overheating, it could result in a BLEVE you find batteries for material handling equipment being recharged in a small warehouse storage room. This causes generation of hydrogen gas, which is explosive. What safety precautions need to be taken? - Venting above the operation Flashover in a compartment is influenced by which of the following? - The ambient temperature A fire involving energized electrical equipment is a: - Class C fire heat is transferred by invisible waves in: - Radiation The key to BLEVE prevention is: - Cooling the top of the tank Energy created by a chemical reaction is: - Chemical energy The lowest temperature at which a liquid produces flammable vapor is the: - Flash Point the fire tetrahedron contains: - Fuel, Oxygen, Chain Reaction, Heat The first phase in a solid-fuel fire is: - Ignition Which of the following is a method of extinguishment? - Removing fuel from the fire A fire involving combustible cooking oils and fats in a kitchen is a: - Class K fire Which statement is true about a gas with a vapor density less than 1? - It will rise to the top of the confined space What do you plan to do in preparation for making the initial inspection? - Look in the file of the toy company's current location for past history of violations and the degree of compliance Before you get a request to inspect the building, the owner invites you to visit the old location and meet with him to discuss code compliance in the new building. - Meet with the owner and tour the building to find out what you will have to address when they move You learn that manufacturing toys requires vast amounts of different kinds of chemicals, some of which react with each other. How do you feel is the best way to handle this? - Learn who the chemical supplier is and ask for assistance It appears that this inspection is going to be very complex and confusing, so the best format to use for the inspection report would be: - A detailed report in essay form with attachments received from suppliers An inspection that occurs wen code violations have been noted and you are checking to see if the owner has fixe them is called a(n): - Reinspection Which of the following statements is true about kitchen cooking equipment? - The inspector should ensure that grease hoods are being cleaned and maintained properly Ordinary wood-frame construction (the typical single-family house) is classified as: - Type V construction When it comes to elevators, which of the following statements is true? - The fire inspector is not involved in their actual testing If an owner shows hostility, which of the following actions would be best for the fire inspector? - Ask if another fire inspector can perform the inspection Building contents that are likely to burn very rapidly and from which explosion is likely are known as: - High hazard contents A type of inspection that is performed by the business owner rather than the fire inspector is the: - Self-inspection