IFSTA 7 Exam Question Bank, With Complete
Solutions, A+ Guide
Which product of combustion acts as a chemical asphyxiant by excluding oxygen
from the blood, leading to hypoxia of the brain and tissues?
A) Carbon dioxide (CO2)
B) Carbon monoxide (CO)
C) Aerosolized fuel particles
D) Hydrogen cyanide (HCN) - B
Combustion can occur within a range of concentration of fuel vapor and air; this
range is referred to as the:
A) vapor pressure range.
B) surface to mass range.
C) flammable (explosive) range.
D) oxidation (combustion) range. - C
Which statement describes the factor that MOST influences compartment fire
development?
A) Whether the fire is fuel-limited or ventilation-limited
B) Whether the fuel is cellulose-based or petroleum-based
C) Ratio of square footage to ceiling height of the compartment
D) Ambient temperature and wind speed outside the compartment - A
An extinguishing agent, such as dry chemical or Halon-replacement agent,
terminates the combustion reaction by:
A) cutting off the oxygen supply to the fuel.
B) interfering with the chemical chain reaction.
C) cooling the fuel below the ignition temperature.
D) reacting with the fuel to create a fire-resistant layer. - B
Materials that burn at normal oxygen levels will burn more intensely in _____
atmospheres.
A) flaming
B) nonflaming
,C) oxygen-enriched
D) oxygen-deficient - C
Which situation would likely be granted an exception to the rule that prohibits
filling an unshielded air cylinder while a firefighter is wearing the SCBA?
A) The SCBA was manufactured within the past five to ten years.
B) A rapid intervention crew (RIC) is rescuing a trapped or incapacitated
firefighter.
C) The firefighter filling the empty cylinder is wearing full structural personal
protective equipment.
D) A firefighter with a higher rank than the firefighter wearing the SCBA cylinder
is available to perform the refill. - B
What is a general safety precaution to take when refilling an SCBA cylinder?
A) Wear full structural fire fighting PPE.
B) Fill the cylinder as quickly as possible.
C) Perform a hydrostatic test on the cylinder.
D) Check the hydrostatic test date of the cylinder. - D
Which piece of information must be included on the permanent compliance label
inside each piece of PPE?
A) Firefighter's name
B) Department name
C) Cleaning precautions
D) Wearing instructions - C
Which type of breathing air source would be found inside a high-rise building?
A) Stationary fill system
B) Auto-cascade fill system
C) High-rise specific cascade system
D) Firefighter Breathing Air Replenishment System - D
Annual SCBA inspections and maintenance should be performed by:
A) a company officer.
B) all available firefighters.
, C) specially trained, factory-qualified technicians.
D) the highest-ranking fire department personnel. - C
After each use, the SCBA facepiece should be:
A) cleaned, dried, and placed out of service.
B) washed with warm water and a mild disinfectant.
C) sanitized using a machine built specifically for facepieces.
D) sent to the manufacturer for a commercial-grade cleaning. - B
When donning an unmounted SCBA, the SCBA unit should be:
A) stored in an outside compartment of the apparatus.
B) placed on the ground with all of the straps extended.
C) stored in a specialized compartment inside the apparatus.
D) placed behind the firefighter with all of the straps tightened. - B
Immediately prior to donning SCBA, firefighters should:
A) record inspections in the SCBA log.
B) perform a hydrostatic test on the cylinder.
C) check to make sure that the bypass valve is disabled.
D) check the cylinder gauge to make sure the cylinder is full. - D
All PPE designed for structural fire fighting must meet the requirements of:
A) NFPA 1002.
B) NFPA 1006.
C) NFPA 1971.
D) NFPA 1981. - C
How can a firefighter help ensure that they will not be affected by limitations
caused by equipment that is in poor condition?
A) Proper facepiece fit testing
B) Repeated training with the SCBA unit
C) Frequent inspections and maintenance
D) Physical fitness and endurance training - C
Solutions, A+ Guide
Which product of combustion acts as a chemical asphyxiant by excluding oxygen
from the blood, leading to hypoxia of the brain and tissues?
A) Carbon dioxide (CO2)
B) Carbon monoxide (CO)
C) Aerosolized fuel particles
D) Hydrogen cyanide (HCN) - B
Combustion can occur within a range of concentration of fuel vapor and air; this
range is referred to as the:
A) vapor pressure range.
B) surface to mass range.
C) flammable (explosive) range.
D) oxidation (combustion) range. - C
Which statement describes the factor that MOST influences compartment fire
development?
A) Whether the fire is fuel-limited or ventilation-limited
B) Whether the fuel is cellulose-based or petroleum-based
C) Ratio of square footage to ceiling height of the compartment
D) Ambient temperature and wind speed outside the compartment - A
An extinguishing agent, such as dry chemical or Halon-replacement agent,
terminates the combustion reaction by:
A) cutting off the oxygen supply to the fuel.
B) interfering with the chemical chain reaction.
C) cooling the fuel below the ignition temperature.
D) reacting with the fuel to create a fire-resistant layer. - B
Materials that burn at normal oxygen levels will burn more intensely in _____
atmospheres.
A) flaming
B) nonflaming
,C) oxygen-enriched
D) oxygen-deficient - C
Which situation would likely be granted an exception to the rule that prohibits
filling an unshielded air cylinder while a firefighter is wearing the SCBA?
A) The SCBA was manufactured within the past five to ten years.
B) A rapid intervention crew (RIC) is rescuing a trapped or incapacitated
firefighter.
C) The firefighter filling the empty cylinder is wearing full structural personal
protective equipment.
D) A firefighter with a higher rank than the firefighter wearing the SCBA cylinder
is available to perform the refill. - B
What is a general safety precaution to take when refilling an SCBA cylinder?
A) Wear full structural fire fighting PPE.
B) Fill the cylinder as quickly as possible.
C) Perform a hydrostatic test on the cylinder.
D) Check the hydrostatic test date of the cylinder. - D
Which piece of information must be included on the permanent compliance label
inside each piece of PPE?
A) Firefighter's name
B) Department name
C) Cleaning precautions
D) Wearing instructions - C
Which type of breathing air source would be found inside a high-rise building?
A) Stationary fill system
B) Auto-cascade fill system
C) High-rise specific cascade system
D) Firefighter Breathing Air Replenishment System - D
Annual SCBA inspections and maintenance should be performed by:
A) a company officer.
B) all available firefighters.
, C) specially trained, factory-qualified technicians.
D) the highest-ranking fire department personnel. - C
After each use, the SCBA facepiece should be:
A) cleaned, dried, and placed out of service.
B) washed with warm water and a mild disinfectant.
C) sanitized using a machine built specifically for facepieces.
D) sent to the manufacturer for a commercial-grade cleaning. - B
When donning an unmounted SCBA, the SCBA unit should be:
A) stored in an outside compartment of the apparatus.
B) placed on the ground with all of the straps extended.
C) stored in a specialized compartment inside the apparatus.
D) placed behind the firefighter with all of the straps tightened. - B
Immediately prior to donning SCBA, firefighters should:
A) record inspections in the SCBA log.
B) perform a hydrostatic test on the cylinder.
C) check to make sure that the bypass valve is disabled.
D) check the cylinder gauge to make sure the cylinder is full. - D
All PPE designed for structural fire fighting must meet the requirements of:
A) NFPA 1002.
B) NFPA 1006.
C) NFPA 1971.
D) NFPA 1981. - C
How can a firefighter help ensure that they will not be affected by limitations
caused by equipment that is in poor condition?
A) Proper facepiece fit testing
B) Repeated training with the SCBA unit
C) Frequent inspections and maintenance
D) Physical fitness and endurance training - C
