pipe fitter test with 100% correct answers

What does TE in TE-601 stand for? - ANSWER-temperature element what does B.T.U stand for? - ANSWER-British Thermal Unit what is the boiling point of water? - ANSWER-212*F What is 3.1416? - ANSWER-Pi what is the circumference of a 15" pipe? (to the nearest tenth0 - ANSWER-47" 4" in the hundredths of a foot is? - ANSWER-.33 what is the take off for a 4" x 3" LR reducing 90* ell? - ANSWER-6" on isometric drawings what does RFWN mean? - ANSWER-raised face weld neck what does the Pi in Pi-209 stand for? - ANSWER-pressure indicator 101.25' converted into inches is what? - ANSWER-101'-3" if testing the shell side of an exchanger with the flat cap removed and all the tubes on the bottom row had a steady flow of water pouring out of them, this would indicate: - ANSWER-floating head gasket leaking 3/4" is equal to? - ANSWER-6/8 the lap joint flange is usually used when_______? - ANSWER-flange hold alignment is a problem what is the number of a square feet in the surface of a steel plate 180 inches high and 48 inches wide? - ANSWER-60 square feet what device is installed between a control valve and the air supply header? - ANSWER-regulator what is the most common degree of bevel on a pipe to be butt welded? - ANSWER-37 1/2 the three states of matter are: - ANSWER-solids, liquids,and gases what is the circumference of a circle that has a 20.50 inch diameter? - ANSWER-64.37 extension lines should: - ANSWER-always touch the object being drawn what is 23% of 1598? - ANSWER-367.54 what is the circumference of a circle with a diameter of 5" - ANSWER-15.70" what is the area of a triangle that is 30.5 feet long and 15 feet wide? (A=WxL) - ANSWER-457.5 square feet a globe valve is used to: - ANSWER-prevent flow in more than one direction what would be the take off for a 45 standard 3" pipe ells? - ANSWER-4" when using orifice flanges in a vapor service, the taps should be facing: - ANSWER-up what dies T.O.E stand for? - ANSWER-thread one end what does BLETSE stand for? - ANSWER-bevel large end/thread small end tools that require hearing protection when used are: - ANSWER-chipping gun, side grinder, air impact items to look for on a bench grinder before use are: - ANSWER-cracked wheel, tool rest within "1/8" of wheel, tongue guard attatched if you wanted to reduce in a line but keep the same center line, you would use an eccentric reducer - ANSWER-false the 2 most commonly used types of tubing connections are compression and flared. - ANSWER-true a pressure indicator is indicated by a Pi symbol on a flow chart - ANSWER-true a pressure indicator is indicated by a PI symbol on a flow chart - ANSWER-true spray painting or modifying hard hats may damage them - ANSWER-true pipe stamped with 316L and 304L denotes a grade or type of a carbon steel pipe and fittings. - ANSWER-false flange insulators Kits are installed for a cathodic protection - ANSWER-true the proper way to lift is bend at your knees and let you legs do the lifting - ANSWER-true exposure to high level noises can be controlled - ANSWER-true to reduce chances of heat stress you should drink plenty of beet and alcohol - ANSWER-false a temperature indicator is indic