Which of the following materials is bonded by resin and used as shim stock?
Give this one a try later!
Laminated brass
What is used to highlight wear pattern in gear teeth?
,Give this one a try later!
Bluing
To check a motor for binding or tough spots,
Give this one a try later!
Turn the rotor by hand
What are the two types of blades used in steam turbines?
Give this one a try later!
Impulse and reaction blades
Which of the following is a high pressure pump?
Give this one a try later!
Diaphragm metering
Which shade of tinted lens should be used when oxy-fuel cutting and welding?
Give this one a try later!
, 4-6
When placed in a vice, how should a polished shaft be protected from pressure
marks and scratches?
Give this one a try later!
Use soft jaws
On assembly, what is used to identify sub assemblies?
Give this one a try later!
Circles
____________ of the same width are to be aligned, alignment normally starts from the
Give this one a try later!
Pulleys; outer face of the stationary pulley to the outer face of the
adjustable pulley
A shim should cover what minimum percent of the area being shimmed?
Give this one a try later!
Give this one a try later!
Laminated brass
What is used to highlight wear pattern in gear teeth?
,Give this one a try later!
Bluing
To check a motor for binding or tough spots,
Give this one a try later!
Turn the rotor by hand
What are the two types of blades used in steam turbines?
Give this one a try later!
Impulse and reaction blades
Which of the following is a high pressure pump?
Give this one a try later!
Diaphragm metering
Which shade of tinted lens should be used when oxy-fuel cutting and welding?
Give this one a try later!
, 4-6
When placed in a vice, how should a polished shaft be protected from pressure
marks and scratches?
Give this one a try later!
Use soft jaws
On assembly, what is used to identify sub assemblies?
Give this one a try later!
Circles
____________ of the same width are to be aligned, alignment normally starts from the
Give this one a try later!
Pulleys; outer face of the stationary pulley to the outer face of the
adjustable pulley
A shim should cover what minimum percent of the area being shimmed?
Give this one a try later!
