Soldering Practices Module 1 and 2 Test
2024-2025. Questions and Correct Answer.
Graded A+
"Products where continued performance and extended life is required,
and for which uninterrupted service is desired but not critical" describes
which of the following classes of product? - ANSClass 2
A CIS candidate may challenge any of the workmanship skills training
programs by _____. - ANSCompleting the same requirements of those
taking the classroom course.
A CIS may teach and certify ________? - ANSNo one else
A clause of the J-STD-001G that is preceded by the symbol representing
the International Space Station (ISS) indicates ________ . - ANSThat
there is a difference between the base document and the space
addendum
A solder connection that exhibits poor wetting and that is characterized
by a grayish porous appearance defines? - ANSCold solder connection
A substance, debris, particulate matter or article alien to the assembly
or system defines ________. - ANSFOD (foreign object debris)
, A tool that is used to cut leads shall not cause damage to a component
lead seal or internal connections. A violation of this requirement would
be ________. - ANSD1D2D3
Adhesive material that is not properly cured is considered ________. -
ANSD1D2D3
All instructors, operators and all inspection personnel __________ be
proficient in the tasks to be performed. - ANSShall
All IPC certification programs for MIT, CIT, and CIS require recertification
after what period of time? - ANS2 years
An operator is found to be soldering heat sensitive components without
the use of heat sinks. The condition is ________. - ANSD1D2D3
Any violation of minimum electrical clearance would be considered
__________ condition for all three classes? - ANSa Defect
Certification once attained belongs to the_________. - ANSIndividual
who completed the training
2024-2025. Questions and Correct Answer.
Graded A+
"Products where continued performance and extended life is required,
and for which uninterrupted service is desired but not critical" describes
which of the following classes of product? - ANSClass 2
A CIS candidate may challenge any of the workmanship skills training
programs by _____. - ANSCompleting the same requirements of those
taking the classroom course.
A CIS may teach and certify ________? - ANSNo one else
A clause of the J-STD-001G that is preceded by the symbol representing
the International Space Station (ISS) indicates ________ . - ANSThat
there is a difference between the base document and the space
addendum
A solder connection that exhibits poor wetting and that is characterized
by a grayish porous appearance defines? - ANSCold solder connection
A substance, debris, particulate matter or article alien to the assembly
or system defines ________. - ANSFOD (foreign object debris)
, A tool that is used to cut leads shall not cause damage to a component
lead seal or internal connections. A violation of this requirement would
be ________. - ANSD1D2D3
Adhesive material that is not properly cured is considered ________. -
ANSD1D2D3
All instructors, operators and all inspection personnel __________ be
proficient in the tasks to be performed. - ANSShall
All IPC certification programs for MIT, CIT, and CIS require recertification
after what period of time? - ANS2 years
An operator is found to be soldering heat sensitive components without
the use of heat sinks. The condition is ________. - ANSD1D2D3
Any violation of minimum electrical clearance would be considered
__________ condition for all three classes? - ANSa Defect
Certification once attained belongs to the_________. - ANSIndividual
who completed the training
