Pipe Fitter Test Questions with Correct
Answers
What does TE in TE-601 stand for? - Correct Answer temperature element
what does B.T.U stand for? - Correct Answer British Thermal Unit
what is the boiling point of water? - Correct Answer 212*F
What is 3.1416? - Correct Answer Pi
what is the circumference of a 15" pipe? (to the nearest tenth0 - Correct Answer 47"
4" in the hundredths of a foot is? - Correct Answer .33
what is the take off for a 4" x 3" LR reducing 90* ell? - Correct Answer 6"
on isometric drawings what does RFWN mean? - Correct Answer raised face weld neck
what does the Pi in Pi-209 stand for? - Correct Answer pressure indicator
101.25' converted into inches is what? - Correct Answer 101'-3"
if testing the shell side of an exchanger with the flat cap removed and all the tubes on the bottom
row had a steady flow of water pouring out of them, this would indicate: - Correct Answer floating
head gasket leaking
3/4" is equal to? - Correct Answer 6/8
the lap joint flange is usually used when_______? - Correct Answer flange hold alignment is a
problem
Answers
What does TE in TE-601 stand for? - Correct Answer temperature element
what does B.T.U stand for? - Correct Answer British Thermal Unit
what is the boiling point of water? - Correct Answer 212*F
What is 3.1416? - Correct Answer Pi
what is the circumference of a 15" pipe? (to the nearest tenth0 - Correct Answer 47"
4" in the hundredths of a foot is? - Correct Answer .33
what is the take off for a 4" x 3" LR reducing 90* ell? - Correct Answer 6"
on isometric drawings what does RFWN mean? - Correct Answer raised face weld neck
what does the Pi in Pi-209 stand for? - Correct Answer pressure indicator
101.25' converted into inches is what? - Correct Answer 101'-3"
if testing the shell side of an exchanger with the flat cap removed and all the tubes on the bottom
row had a steady flow of water pouring out of them, this would indicate: - Correct Answer floating
head gasket leaking
3/4" is equal to? - Correct Answer 6/8
the lap joint flange is usually used when_______? - Correct Answer flange hold alignment is a
problem
