Unit 5 - Codes & Standards Questions
with Verified Answers
A body formed in 1919 for the promotion of safety and uniformity in the construction,
installation and inspection of boilers and pressure vessels was the: -
ANSWERSNational Board of Boiler and Pressure Vessel Inspectors.
The code that regulates mechanical refrigeration is: - ANSWERSCSA B-52
When a fitting is to be registered within a jurisdiction an application must be made to: -
ANSWERSthe Chief Inspector.
Before an inspector issues the first certificate of inspection for any boiler and/or
pressure vessel, he must make sure the vessel is ___________ with the jurisdiction's
identification number. - ANSWERSstamped
The ASME publication dealing with the care of heating boilers is: - ANSWERSSection
VI.
Before a fitting is to be constructed in the jurisdiction for use in the jurisdiction,
application must be made to the Chief Inspector for: - ANSWERSregistration.
The Act and Regulations do not apply to a heating plant having a: - ANSWERSboiler
rating of 10 kW or less.
The welds of a pressure welder are identified by: - ANSWERSa stamp.
If there were a conflict between codes in ASME Section 1 and CSA B-51, which code
would take precedence? - ANSWERSCSA B-51
Before starting up any boiler it is necessary that: - ANSWERSit have a valid inspection
certificate.
A low pressure steam boiler is one which operates: - ANSWERSat or below 103 kPa.
Boiler structural strength must: - ANSWERSbe at least equal to the various code
requirements.
Pan-Canadian law means jurisdiction: - ANSWERSin all provinces and territories.
Heating boiler means a: - ANSWERSboiler where steam is produced at a pressure of
103 kPa or less.
with Verified Answers
A body formed in 1919 for the promotion of safety and uniformity in the construction,
installation and inspection of boilers and pressure vessels was the: -
ANSWERSNational Board of Boiler and Pressure Vessel Inspectors.
The code that regulates mechanical refrigeration is: - ANSWERSCSA B-52
When a fitting is to be registered within a jurisdiction an application must be made to: -
ANSWERSthe Chief Inspector.
Before an inspector issues the first certificate of inspection for any boiler and/or
pressure vessel, he must make sure the vessel is ___________ with the jurisdiction's
identification number. - ANSWERSstamped
The ASME publication dealing with the care of heating boilers is: - ANSWERSSection
VI.
Before a fitting is to be constructed in the jurisdiction for use in the jurisdiction,
application must be made to the Chief Inspector for: - ANSWERSregistration.
The Act and Regulations do not apply to a heating plant having a: - ANSWERSboiler
rating of 10 kW or less.
The welds of a pressure welder are identified by: - ANSWERSa stamp.
If there were a conflict between codes in ASME Section 1 and CSA B-51, which code
would take precedence? - ANSWERSCSA B-51
Before starting up any boiler it is necessary that: - ANSWERSit have a valid inspection
certificate.
A low pressure steam boiler is one which operates: - ANSWERSat or below 103 kPa.
Boiler structural strength must: - ANSWERSbe at least equal to the various code
requirements.
Pan-Canadian law means jurisdiction: - ANSWERSin all provinces and territories.
Heating boiler means a: - ANSWERSboiler where steam is produced at a pressure of
103 kPa or less.
