Mechanics Exam NEIEP EXAM ALL 350 QUESTIONS AND VERIFIED SOLUTIONS LATEST UPDATE THIS YEAR

Page 1 of 64




Mechanics Exam NEIEP EXAM ALL 350
QUESTIONS AND VERIFIED SOLUTIONS
LATEST UPDATE THIS YEAR


QUESTION: How do you determine the correct angle from the vertical for placing a ladder -

ANSWER-Measure out a distance of 1/4 the height.




QUESTION: Who is required to furnish you the necessary safety equipment? - ANSWER-Your

employer




QUESTION: What device must be in working condition in order to use an elevator car sling as a

running platform - ANSWER-The governor and safeties.




QUESTION: What hazardous condition can occur if the weight of the temporary car and

counterweight are not kept nearly equal? - ANSWER-Traction could be lost




QUESTION: What is the name of the document that lists the hazards of a substance? - ANSWER-

Material Safety Data Sheet or Safety Data Sheet




1

, Page 2 of 64




QUESTION: Who is responsible for making sure barricades are kept in place? - ANSWER-

Everyone on the job




QUESTION: Who is primarily responsible for your safety on the job? - ANSWER-You, Yourself




QUESTION: Which agency guarantees your right to a safe workplace? - ANSWER-OSHA




QUESTION: Which of the following is not a typical elevator repair? - ANSWER-




QUESTION: Which of the following makes a good substitute for a ladder? - ANSWER-Never

substitute anything




QUESTION: How should you proceed to et a toolbox to the machine room when climbing a

vertical ladder? - ANSWER-Climb the ladder and pull the box up with a rope




QUESTION: What is the safest way to lubricate hoist ropes? - ANSWER-With a rope lubricator




2

, Page 3 of 64


QUESTION: What supports a hydraulic elevator? - ANSWER-The column of oil inside the jack




QUESTION: What is the first thing you must do before performing any service on an elevator -

ANSWER-Place barricades at the upper and lower ends


What is the time constant for a circuit with 150KOhms and a 2 microfarad capacitor? -

ANSWER-.3 seconds




QUESTION: What must be done before checking pump drive belts on a hydraulic elevator -

ANSWER-Pull the main disconnect switch




QUESTION: Which of the following best describes the danger posed be the counterweight

assembly when you are riding the car top? - ANSWER-It run close by in the opposite direction




QUESTION: Why must you place a hydraulic elevator car on jack posts before servicing the

packing head? - ANSWER-Because a hydraulic elevator is supported by a column of oil.




QUESTION: Why can't Elevator Constructors use a metal ladder? - ANSWER-Metal ladders

conduct electricity




3

, Page 4 of 64




QUESTION: What is the function of a Ground Fault Circuit Interrupter? - ANSWER-To detect and

imbalance in current between the hot and nuetral wires




QUESTION: When a roller bearing needs to be pressed onto a shaft, what type of allowance

does the shaft have? - ANSWER-Negative allowance




QUESTION: How are threads specified on metric bolts? - ANSWER-




QUESTION: What is the tolerance accepted in the elevator industry? - ANSWER-+- 1/64




QUESTION: What type of locking device uses a second nut run up against the first which flattens

when tightened? - ANSWER-




QUESTION: How many possible views are there available from drawings using orthographic

projections? - ANSWER-




4