IMSA Signal Technician Level 1 End of
Chapter Questions
What is the primary function of the IMSA? - answersSafety education
IMSA stands for: - answersInternational Municipal Signal Association
Which of the following is NOT an IMSA certification? - answersY: Traffic Signal Level II Design/Engineer
Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - answersOverhead and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - answersCircular red, circular green
PPE stands for: - answersPersonal Protective Equipment
Which of the follow is an example of adequate fall protection during the operation of aerial lift equipment? -
answersFull body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? - answersEnsure advance warning
devices have not been removed or relocated
, Which of the following is NOT a sentence type in the MUTCD? - answersY: Standards; requirements that have
to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic Control Signals: -
answersThree-section traffic signal with circular red, circular yellow, and smaller circular yellow indications
The following phases are typically assigned to the major street through movements: - answers2 and 6
The green interval is made up which three components? - answersMinimum green, passage time, maximum
green
What are the three types of recall features of a traffic signal controller? - answersMinimum, maximum,
pedestrian (+soft)
In a coordination plan, what is the number of seconds given to each phase at the intersection? - answersSplit
(g,y,r)
Which of the following traffic signal coordination method is typically least expensive? - answersTime-based
coordination
Which of the following is a definition of cycle length: - answersThe elapsed time between the start of a specific
display until that display comes up again
Which of the following is a characteristic of sequential phases: - answersThey cannot occur at the same time
Which of the following is a definition for initial green time: - answersMinimum time that the green indication
must be displayed
The only point in the cycle of a coordinated traffic signal controller where the major-street phase is allowed to
end is called: - answersYield point
Chapter Questions
What is the primary function of the IMSA? - answersSafety education
IMSA stands for: - answersInternational Municipal Signal Association
Which of the following is NOT an IMSA certification? - answersY: Traffic Signal Level II Design/Engineer
Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - answersOverhead and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - answersCircular red, circular green
PPE stands for: - answersPersonal Protective Equipment
Which of the follow is an example of adequate fall protection during the operation of aerial lift equipment? -
answersFull body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? - answersEnsure advance warning
devices have not been removed or relocated
, Which of the following is NOT a sentence type in the MUTCD? - answersY: Standards; requirements that have
to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic Control Signals: -
answersThree-section traffic signal with circular red, circular yellow, and smaller circular yellow indications
The following phases are typically assigned to the major street through movements: - answers2 and 6
The green interval is made up which three components? - answersMinimum green, passage time, maximum
green
What are the three types of recall features of a traffic signal controller? - answersMinimum, maximum,
pedestrian (+soft)
In a coordination plan, what is the number of seconds given to each phase at the intersection? - answersSplit
(g,y,r)
Which of the following traffic signal coordination method is typically least expensive? - answersTime-based
coordination
Which of the following is a definition of cycle length: - answersThe elapsed time between the start of a specific
display until that display comes up again
Which of the following is a characteristic of sequential phases: - answersThey cannot occur at the same time
Which of the following is a definition for initial green time: - answersMinimum time that the green indication
must be displayed
The only point in the cycle of a coordinated traffic signal controller where the major-street phase is allowed to
end is called: - answersYield point
