MAE 272- Review 1 Questions and
Answers|Latest Update
Which process is not required to produce 3-piece welded steel cans: deep drawing
Cold forming of metals is done at: T/Tm just below 0.3
Progressive dies are preferred over compound dies due to: simpler design and lower
maintenance costs
Vickers (HV) is: none is correct
Engine hoods, fenders, boot lids, etc., of mid-size sedans are usually: stretched formed
and-or deep drawn
An estimate for job cost as per customer's RfQ should include: all answers except
dimensions and tolerances
, A round keyway in a round shaft can be produced by: sink EDM
The threaded base of a light bulb can be produced cost-effectively by: all answers are
wrong
Angles such as chamfers can be measured by using: Protractors
Climb milling is: aka down milling, hence requires more torque per unit of material
removed than turning
Sand casting is: none of the following
Continuous casting is: none of the following
Router or traveler is: optimized operation sequences with set-up and run times
Which is called the lost-wax casting: pattern is melted out for recycling before pouring
Answers|Latest Update
Which process is not required to produce 3-piece welded steel cans: deep drawing
Cold forming of metals is done at: T/Tm just below 0.3
Progressive dies are preferred over compound dies due to: simpler design and lower
maintenance costs
Vickers (HV) is: none is correct
Engine hoods, fenders, boot lids, etc., of mid-size sedans are usually: stretched formed
and-or deep drawn
An estimate for job cost as per customer's RfQ should include: all answers except
dimensions and tolerances
, A round keyway in a round shaft can be produced by: sink EDM
The threaded base of a light bulb can be produced cost-effectively by: all answers are
wrong
Angles such as chamfers can be measured by using: Protractors
Climb milling is: aka down milling, hence requires more torque per unit of material
removed than turning
Sand casting is: none of the following
Continuous casting is: none of the following
Router or traveler is: optimized operation sequences with set-up and run times
Which is called the lost-wax casting: pattern is melted out for recycling before pouring
