Carpentry 1 Module 1 Questions and Answers | Latest Version | 2024/2025 | Correct & Verified

Carpentry 1 Module 1 Questions and Answers | Latest Version | 2024/2025 | Correct & Verified What is the best way to ensure a smooth edge after cutting wood? Sand the edge with progressively finer grit sandpaper. Why is it important to know the species of wood being used? Different wood species have varying strengths, densities, and appearances. What should you do if a power cord is damaged on a tool? Stop using the tool immediately and have the cord repaired or replaced. What is the purpose of a bevel gauge? To measure and replicate angles accurately on wood. Why should wood glue be wiped off before it dries? Dried glue can interfere with finishes and leave an uneven surface. 2 How can you avoid splitting wood when nailing close to the edge? Drill pilot holes before driving the nails. What is the main use of a coping saw? To cut intricate shapes and curves in wood. Why is it important to follow the grain when chiseling wood? Going against the grain can cause splintering or uneven cuts. What is the purpose of a biscuit joiner? To create slots for wooden biscuits, which strengthen joints. Why should you check the moisture content of wood before building? Wet wood can shrink and warp as it dries. What is the safest way to handle long boards while cutting them? Support both ends to prevent tipping or binding. 3 Why should sharp tools always be used in carpentry? Dull tools require more force and can lead to accidents or poor results. What is the purpose of countersinking screws? To allow the screw head to sit flush or below the wood surface. How can you ensure a consistent depth when drilling holes? Use a drill stop or mark the desired depth on the bit. What is the best way to prevent wood dust from spreading in a workshop? Use a dust collection system or vacuum while working. Why should you avoid over-tightening clamps? Excessive pressure can damage the wood or distort the joint. How do you identify a warped board? Sight along its edge or lay it on a flat surface