TTT Test Exam Questions With
Revised Correct Detailed Answers
1. Who is the third party group that approves and endorses standards? -
ANSWER American National Standards Institute
2. What term is used to describe the documents written by members, or
peers, in the industry? - ANSWER Standards
3. A company's health, safety and environment policy should be a
combination of labor regulations and ? - ANSWER Industry standards
4. Where OSHA has not promulgated specific standards, who is responsible
for following the acts general clause? - ANSWER Employer
5. On a job site who should be involved in the JHA process? - ANSWER
The Whole Crew
6. What does the Term SOW stand for? - ANSWER Scope Of Work
7. The letters JHA stand for what ? - ANSWER Job Hazard Assessment
8. When using a extension ladder, how many feet past the platform must it
extend? - ANSWER 3
, 9. If you have a sixteen foot ladder leaning against a building wall, how many
feet from the wall does the case need to by to have the correct slope? -
ANSWER 4
10. Work boots with ankle support are recommended for all work sites? -
ANSWER True
11.What do the letters PPE stand for ? - ANSWER Personal Protective
Equipment
12. What does the ground fault circuit interrupter (GFCI) do? - ANSWER
Senses a short circuit, prevents electrocution , shuts off the flow of
electricity
13. Who is responsible for providing PPE? - ANSWER Employer
14. When using a y-lanyard attached to your back d-ring, at what height should
the connection to your anchorage be placed?extend? - ANSWER
Shoulder level or above
15. What is the maximum distance between the sternal d-ring and the fixed safety
climb? - ANSWER Nine inches
16. When calculating a fall distance using a "6 foot" energy absorbed, what is
the maximum pull out distance? - ANSWER Four feey
Revised Correct Detailed Answers
1. Who is the third party group that approves and endorses standards? -
ANSWER American National Standards Institute
2. What term is used to describe the documents written by members, or
peers, in the industry? - ANSWER Standards
3. A company's health, safety and environment policy should be a
combination of labor regulations and ? - ANSWER Industry standards
4. Where OSHA has not promulgated specific standards, who is responsible
for following the acts general clause? - ANSWER Employer
5. On a job site who should be involved in the JHA process? - ANSWER
The Whole Crew
6. What does the Term SOW stand for? - ANSWER Scope Of Work
7. The letters JHA stand for what ? - ANSWER Job Hazard Assessment
8. When using a extension ladder, how many feet past the platform must it
extend? - ANSWER 3
, 9. If you have a sixteen foot ladder leaning against a building wall, how many
feet from the wall does the case need to by to have the correct slope? -
ANSWER 4
10. Work boots with ankle support are recommended for all work sites? -
ANSWER True
11.What do the letters PPE stand for ? - ANSWER Personal Protective
Equipment
12. What does the ground fault circuit interrupter (GFCI) do? - ANSWER
Senses a short circuit, prevents electrocution , shuts off the flow of
electricity
13. Who is responsible for providing PPE? - ANSWER Employer
14. When using a y-lanyard attached to your back d-ring, at what height should
the connection to your anchorage be placed?extend? - ANSWER
Shoulder level or above
15. What is the maximum distance between the sternal d-ring and the fixed safety
climb? - ANSWER Nine inches
16. When calculating a fall distance using a "6 foot" energy absorbed, what is
the maximum pull out distance? - ANSWER Four feey
