VIVINT SHP PRACTICE EXAM 130Q TEST AND
ANSWERS
True or false the fire fighter may be installed next to a standalone battery powered smoke
detector - -False
True or false when performing a full system test you may bypass any open doors or
windows - -False
When programming and SKEY1 you must: - -Always enable the emergency key
True or false when running power to the take-345, polarity does not matter - -False
Select all that apply when programming the emergency key for SKEY1 one which
zone/sensor types are recommended to use - -Audible alarm 07 auxiliary alarm 08
True or false when installing a SMKT3 you must use the included screws and anchors -
-True
True or false when installing the fire fighter it is required to test the customers existing
smoke detectors - -True
When installing a DW 21 where is the approved location for the sensor - -Between 6
inches (15cm) and 2 inches (61cm) from the floor
When installing a DW11 on a vinyl or metal frame what should you primarily use to mount
the sensor - -Provided double-sided tape
Select all that apply which of the following materials can you use to group multiple ground
terminals in the takeover module - -B connectors/beans and Wire caps
ANSWERS
True or false the fire fighter may be installed next to a standalone battery powered smoke
detector - -False
True or false when performing a full system test you may bypass any open doors or
windows - -False
When programming and SKEY1 you must: - -Always enable the emergency key
True or false when running power to the take-345, polarity does not matter - -False
Select all that apply when programming the emergency key for SKEY1 one which
zone/sensor types are recommended to use - -Audible alarm 07 auxiliary alarm 08
True or false when installing a SMKT3 you must use the included screws and anchors -
-True
True or false when installing the fire fighter it is required to test the customers existing
smoke detectors - -True
When installing a DW 21 where is the approved location for the sensor - -Between 6
inches (15cm) and 2 inches (61cm) from the floor
When installing a DW11 on a vinyl or metal frame what should you primarily use to mount
the sensor - -Provided double-sided tape
Select all that apply which of the following materials can you use to group multiple ground
terminals in the takeover module - -B connectors/beans and Wire caps
