PADI, Open Water Diver, Final Exam Review Correct Questions And Answers

PADI, Open Water Diver, Final Exam Review Correct Questions And Answers D float. Salt water is heavier than fresh water because it has dissolved minerals in it. This means it causes more upward force (buoyancy) on an object. An object that is neutrally buoyant in fresh water would float in salt water because there is greater upward force. See Being a Diver I - Buoyancy and Controlling Buoyancy. - 1) If an object is neutrally buoyant (does not sink or float) in fresh water, the same object placed into salt water would A sink. B either sink or float. C do nothing. D float. B The balloon will get smaller and the air inside the balloon will be more dense (molecules move closer together). As water pressure increases, the volume of an air space will decrease. This causes the density of the air inside to increase and air molecules are pushed closer together. The balloon would get smaller and the air density inside would be greater. See Being a Diver I - Water Pressure and Air Volume Effects. - 2) I blow up a balloon, tie it off, and take it to the bottom of the swimming pool. What will happen to the balloon and the air inside it? A The balloon will get bigger and the air inside the balloon will be less dense (molecules move further apart). B The balloon will get smaller and the air inside the balloon will be more dense (molecules move closer together). C The balloon will get bigger and the air inside the balloon will be more dense. D The balloon will get smaller and the air inside the balloon will be less dense. A become half the size it was at the surface. At 10 meters, the pressure is 2 bar. An air volume taken to this depth from the surface would decrease and become half the size. See Being a Diver I - Water Pressure and Air Volume Effects. - 3) I turn a glass upside down, trap the air in it by putting it in water, and then I take the glass down to 10 meters. The air space would A become half the size it was at the surface. B not change in size. C become 1/3 the size it was at the surface. D become 2/3 the size it was at the surface. C A cold, allergy or another medical problem. A cold, or any congestion, can block air passages in your ears and sinuses, making equalization difficult or impossible. See Being a Diver I - The Effects of Increasing Pressure on Body Air Spaces. - 4) If I am not able to equalize (clear) my body air spaces, it may be because I have A seasickness. B heart disease and high blood pressure. C a cold, allergy or another medical problem. D anxiety. C I am feeling a squeeze and need to equalize. Pain in your ears or sinuses means that they aren't equalized. Stop your descent and ascend slightly to relieve pressure on your ears. Then attempt to equalize again. If you can't equalize, end the dive. See Being a Diver I - The Effects of Increasing Pressure on Body Air Spaces. - 5) If my ears or sinuses hurt while I am descending (going down), it usually means A my air spaces are equalized. B my mask strap is too tight. C I am feeling a squeeze and need to equalize. D my mask is too small. B In the triangle area formed by my chin and the lower corners of my rib cage. Your alternate air source attaches with a quick release in the triangle area formed by your chin and the lower corners of your rib cage. Avoid letting your alternate air source dangle unsecured from your kit. See Equipment I - Regulators. - 6) The best place for me to position an alternate air source is A loose by my side so I can find it fast. B in the triangle area formed by my chin and the lower corners of my rib cage. C to the base of my cylinder. D to the back of my BCD between my shoulder blades and waist. D Holding my breath while scuba diving. Blocking off your lungs by holding your breath and ascending could cause them to overexpand and rupture, which is a serious injury that could result in paralysis and death. Breathing continuously while scuba diving keeps air passages open allowing expanding air to escape. See Being a Diver I - The Effects of Decreasing Pressure on Body Air Spaces. - 7) Lung overexpansion injuries can be caused by A scuba diving without a buddy. B continuing a dive when not properly weighted. C not drinking enough water before scuba diving. D holding my breath while scuba diving. B 20 minutes 60/3=20 For each 10 meters we go down, we have one more atmosphere of pressure. Also, remember to add in the 1 atmosphere of pressure at the surface. So, going down to 20 meters, we will have 2 atm + 1 atm = 3 atm of pressure. - 8) If my cylinder of air lasts 60 minutes while I am at the surface breathing normally, assuming all else is the same, how long will it last at 20 meters breathing normally? A 60 minutes B 20 minutes C 15 minutes D 12 minutes A Once a year. Have your cylinder visually inspected annually for internal corrosion or other contamination/damage. See Equipment I - Cylinders. - 9) How often should I take my scuba cylinder to be visually inspected by my dive center? A Once a year. B Once every two years. C Every six months. D Every five years. D Have threaded openings to screw the regulator into. With the DIN system, the regulator screws into the valve. The yoke system holds the regulator first stage to the cylinder with a clamp system. See Equipment I - Cylinders. - 10) The difference between DIN valves and yoke valves is that DIN valves A are made from durable plastic. B contain a spring-operated shutoff valve that is held open by cylinder pressure. C have an o-ring in them. D have threaded openings to screw the regulator into. C Keep some air in it. You should keep some air in the cylinder to prevent moisture from entering and causing corrosion. Also, have it pressure tested at required intervals, usually two to five years. Have it visually inspected annually. Store it standing in a safe place and keep it away from high heat.