Core Module 3 NCCER exam questions and (VERIFIED) answers rated A

Another name for a machinist hammer is a - Ball-peen hammer A heavy duty tool used to drive post or other large stakes is a - Sledge hammer The proper angle for the edge of a cold chisel - 60 degrees A Reed and Prince screw comes to a relatively sharp point at - the base of it's drive socket When an object is plumb it is - perfectly vertical One situation that can make a measurement with a laser inaccurate is - Measuring to a highly reflective surface. Because of its stiffness, a folding rule is better than a cloth or steel tape for measuring - Vertical distances Coping saw - Used to cut intricate external shapes and interior cut-outs in woodworking or carpentry. Another common name for a lineman's pliers is - Side cutters To quickly run a nut onto a bolt that resists spinning it on with the fingers , you can drive the socket with a - Speed handle. A spud wrench is different from a pipe in that it has - Smooth jaws A hexagonal shape has -Six sidesIn addition to level and plumb, some spirit levels can check a - 45 degree angle Spring clamp - Used to hold materials during gluing; similar to lightweight pliers in which clamping pressure is exerted by a spring. To check level conditions over a significant distance such as a building foundation or longer distance the best level is to use is a - Laser level A rip saw , saws would likely have the fewest teeth per inch resulting in the - largest teeth The best design saw for cutting miter joints is a - Backsaw