NC BLET- Firearms questions with verified solutions 2023/2024

NC BLET- Firearms5 components of semiautomatic pistols - correct answers magazine barrel slide frame spring Bristle brush used to clean ____ and ____ on semiautomatic - correct answers frame, slide ___ to ___ drops of oil used when cleaning semiautomatic - correct answers 6-8 Typical gunfight lasts _ to _ seconds - correct answers 2, 3 4 Steps to drawing - correct answers grip, clear holster, bring to center, align with target When clearing a semiautomatic - correct answers point in a safe direction, drop magazine, physically/visually inspect, rack slide cover vs concealment - correct answers cover stops bullets, concealment hides shooter __% of shooting incidents involve more than one suspect - correct answers 40 the __ ___ of a vehicle affords the best protection when used as cover - correct answers engine block 2 flashlight techniques - correct answers Nonsupported and supported Nonsupported flashlight techniques - correct answers FBI method, Puckett technique Supported flashlight techniques - correct answers Harries, modified harries, stacked When a misfire occurs with a revolver - correct answers keep pulling the trigger Extra magazines in pouch should be placed: - correct answers with the round side forward/towards belt buckle Sight alignment - correct answers relationship of front sight to rear sight Sight picture - correct answers the relationship of the aligned sights to the target When cleaning, once the weapon has been reassembled, perform a - correct answers function check (such as dry firing) One drop of oil goes on a revolver, on the: - correct answers extraction rod Barrel throat on a revolver can be more effectively cleaned by using - correct answers Lewis Lead Remover or a .45 cal brush cylinders on Smith and Wesson revolvers rotate - correct answers counterclockwise cylinders on Colt revolvers rotate - correct answers clockwise Hammer Block - correct answers prevents firing if the hammer on a revolver is struck accidentally or slips during the cocking phase Single action revolver - correct answers hammer must be pulled back with the thumb into a cocked position and the trigger squeezed