CUSP UPDATED TEST PAPER QUESTIONS AND
ANSWERS SURE A+
✔✔Task safety training is needed when a new employee reports to work or when an
employee has been reassigned. Under federal rule - ✔✔When new equipment and new
procedures are employed
✔✔21. Which statement below best describes management leadership in developing
and supporting a workplace safety culture? - ✔✔A. The manager facilitates down and
accepts communication/feedback up
✔✔The following OSHA definition is criteria for what? "One who is capable of identifying
existing and predictable hazards in the surroundings or working conditions which are
unsanitary, hazardous, or dangerous to employees, and who has authorization to take
prompt corrective measures to eliminate - ✔✔A competent person
✔✔18. Specific safety procedures for completion of a task will most likely be found in: -
✔✔Consensus standards
✔✔17. Which one of the following activities would be considered a leading indicator of a
zero incident culture? - ✔✔A. Routine and effective use of task hazard analysis
✔✔16. Which of the following best describes the sound level requirements for backup
alarms on construction site vehicles? - ✔✔Above ambient sound level in the area of
exposure
✔✔14. A detailed study to identify the cause of the incident is best described by which
of the following? - ✔✔Root cause analysis
✔✔13. What consideration is required of the employer when selecting what PPE to use
and when to use it? - ✔✔B. Workplace hazards and injury statistics
, ✔✔In the 2010 crane and derrick final rule, which tasks require third-party certification -
✔✔Equipment operators
✔✔11. Which of the following best describes when foot protection is needed for
employees? - ✔✔B. The employer's determination of conditions and previous
experience
✔✔10. Which of the following best describes NESC-accepted requirements for
determining energized or unknown conditions? - ✔✔B. Inspection and testing of lines
and equipment
✔✔9. Which statement below best describes non-mandatory "Advisory Guidelines for
Employer Compliance" published by OSHA? - ✔✔B. Federal register appendices
✔✔8. The following OSHA definition is criteria for what? "A person who, by possession
of a recognized degree, certificate, or professional standing, or who by extensive
knowledge, training and experience, successfully demonstrated the ability to
solve/resolve problems relating to the subject matter, the work, or the project." - ✔✔A. A
qualified person
✔✔7. There is no requirement for a qualified climber to use 100 percent fall protection,
however, a citation could be issued under which of the following conditions? - ✔✔A. The
employer's General Duty Clause requirements where hazards are recognized
✔✔6. In OSHA's 1910.269 standard, the language "nominal voltage, presence of
induction, environmental conditions, presence of grounds" are terms associated with the
rule that requires determination of: - ✔✔Existing conditions
✔✔he OSHA standards for construction and operation of electric utility systems are
found in: - ✔✔OSHA's General Industry Standard 1910 Subpart R
B. OSHA's Construction Industry Standard 1926 Subpart V
✔✔4. Which of the following best describes where statistics regarding face, hand, foot
or head injuries would most likely be found? - ✔✔A. Bureau of Labor Statistics (BLS)
✔✔2. Physical and health hazards, hazcom program criteria, protection methods and a
list of hazardous chemicals are found in what document? - ✔✔OSHA's 1910 General
Industry Standard
✔✔What is Skill based performance? - ✔✔High degree of familarity, low attention
Lowest degree of risk being 1:10000
ANSWERS SURE A+
✔✔Task safety training is needed when a new employee reports to work or when an
employee has been reassigned. Under federal rule - ✔✔When new equipment and new
procedures are employed
✔✔21. Which statement below best describes management leadership in developing
and supporting a workplace safety culture? - ✔✔A. The manager facilitates down and
accepts communication/feedback up
✔✔The following OSHA definition is criteria for what? "One who is capable of identifying
existing and predictable hazards in the surroundings or working conditions which are
unsanitary, hazardous, or dangerous to employees, and who has authorization to take
prompt corrective measures to eliminate - ✔✔A competent person
✔✔18. Specific safety procedures for completion of a task will most likely be found in: -
✔✔Consensus standards
✔✔17. Which one of the following activities would be considered a leading indicator of a
zero incident culture? - ✔✔A. Routine and effective use of task hazard analysis
✔✔16. Which of the following best describes the sound level requirements for backup
alarms on construction site vehicles? - ✔✔Above ambient sound level in the area of
exposure
✔✔14. A detailed study to identify the cause of the incident is best described by which
of the following? - ✔✔Root cause analysis
✔✔13. What consideration is required of the employer when selecting what PPE to use
and when to use it? - ✔✔B. Workplace hazards and injury statistics
, ✔✔In the 2010 crane and derrick final rule, which tasks require third-party certification -
✔✔Equipment operators
✔✔11. Which of the following best describes when foot protection is needed for
employees? - ✔✔B. The employer's determination of conditions and previous
experience
✔✔10. Which of the following best describes NESC-accepted requirements for
determining energized or unknown conditions? - ✔✔B. Inspection and testing of lines
and equipment
✔✔9. Which statement below best describes non-mandatory "Advisory Guidelines for
Employer Compliance" published by OSHA? - ✔✔B. Federal register appendices
✔✔8. The following OSHA definition is criteria for what? "A person who, by possession
of a recognized degree, certificate, or professional standing, or who by extensive
knowledge, training and experience, successfully demonstrated the ability to
solve/resolve problems relating to the subject matter, the work, or the project." - ✔✔A. A
qualified person
✔✔7. There is no requirement for a qualified climber to use 100 percent fall protection,
however, a citation could be issued under which of the following conditions? - ✔✔A. The
employer's General Duty Clause requirements where hazards are recognized
✔✔6. In OSHA's 1910.269 standard, the language "nominal voltage, presence of
induction, environmental conditions, presence of grounds" are terms associated with the
rule that requires determination of: - ✔✔Existing conditions
✔✔he OSHA standards for construction and operation of electric utility systems are
found in: - ✔✔OSHA's General Industry Standard 1910 Subpart R
B. OSHA's Construction Industry Standard 1926 Subpart V
✔✔4. Which of the following best describes where statistics regarding face, hand, foot
or head injuries would most likely be found? - ✔✔A. Bureau of Labor Statistics (BLS)
✔✔2. Physical and health hazards, hazcom program criteria, protection methods and a
list of hazardous chemicals are found in what document? - ✔✔OSHA's 1910 General
Industry Standard
✔✔What is Skill based performance? - ✔✔High degree of familarity, low attention
Lowest degree of risk being 1:10000
