J-STD-001 Final Exam Guide 2025: Space Addendum & Solder Certification Prep

age 1 of 16




J-STD-001 FINAL EXAM PREP 2025/2026 ACCURATE

QUESTIONS WITH CORRECT DETAILED ANSWERS ||

100% GUARANTEED PASS <BRAND NEW VERSION>

Who is responsible for identifying the assembly class?

.......Answer.........User


What is a defect? .......Answer.........A condition that may affect

the form, fit, or function of the item in the end use environment


What is wire overlap? .......Answer.........When a wire is wrapped

more than 360 and crosses over itself


What is wire over wrap? .......Answer.........When a wire is

wrapped more than 360 and remains in contact with the

terminal

,age 2 of 16




Hardware found to not conform to the requirements of the

standard shall be classified as defects and dispositioned for:

.......Answer.........[D1D2D3]


There shall be no broken strands for wires used at a potential of

6kV or greater: .......Answer.........[D1D2D3]


A documented process control system shall be implemented for:

.......Answer.........[N1N2D3]


The contract shall take precedence over this standard for:

.......Answer.........[D1D2D3]


Manufacturers shall perform 100% inspection unless sampling

inspection is defined for: .......Answer.........[N1D2D3]

, age 3 of 16




Inspection of soldering and cleanliness shall be performed prior

to conformal coasting, staking, or encapsulation for:

.......Answer.........[N1D2D3]


Illumination at the surface of work stations should be at least

what? .......Answer.........1000 lux


What is the tolerance for magnification aids? .......Answer.........+-

15%


Eating, drinking, smoking, e-cigs use shall be prohibited at the

work station for: .......Answer.........[D1D2D3]


Manufacturer shall verify ESD is adequate when humidity falls

below 30% for: .......Answer.........[N1D2D3]


Manufacturer shall establish an ESD control program for:

.......Answer.........[D1D2D3]