Med gas 2025| Questions and Answers, 100% Correct

Med gas 2025| Questions and Answers, 100% Correct Which of these three outdoor manifold enclosures are acceptable under the 2012 NFPA 99 Code? Code? a. X, Y, and Z b. Y and Z only c. Zonly d. NFPA 99 does NOT state a requirement C Under which of these conditions shall the instrument air reserve header cylinders be permitted to be stored with the instrument air reserve header cylinders be permitted to be stored with the instrument air a. The mechanical equipment room does NOT contain a boiler. b. The medical air compressors are in the same room. c. The only motor-driven machinery in the room is for the instrument air equipment. d. The room is secured with lockable doors. B Riser valves are those valves located where? a. Adjacent to the main riser downstream of any zone valve b. Anywhere in the lateral branches of the piping system c. In the main line adjacent to the base of the riser d. In the riser adjacent to the main line D Installers of a Category 1 medical gas piped distribution system must be qualified in accordance with ASS: 6010. What is the certification requirement for installers of a Category 3 medical gas piped distribution system? a. 6010 b. 6020 C.6030 d. Category 3 does NOT require certification. A When is the initial pressure test conducted by the Installer? a. After blow down of the distribution piping b. After installation of alarm sensors c. Before blow down of the distribution piping d. Before installation of station rough-in assemblies A those portions of systems intended to handle oxygen at pressures greater than 350 psi, the interconnecting hose shall NOT containmaterials. a. Brass b. Copper c. Polymeric d. Stainless steel Polymeric The tool shown here allows the installer to mechanically limit the makeup depth of the fitting to be brazed. Under what conditions is this method permitted for the installation of medical gas piping? Where the limited make up depth is not less than minimum cup depth per ANSI/ASME recommendations