An example of incident Cost would be? - ✔✔Overtime worked to keep on schedule due to
accident Protect the safety and health of America's workers is the mission of what the
government agrees - ✔✔OSHA The General duty clause states that it is the employers
responsibility to provide a workspace free from - ✔✔recognized hazards To ensure
consistent enforcement OSHA has set up? - ✔✔OSHA Directives the right of workers o
seek safety and health on the job without fear of punishment is found in? - ✔✔section (c)
of the OSHA ACT OSHA requires that employers __ that abatement is complete for each
cited violation. - ✔✔certify An OSHA inspection begins with - ✔✔presentation of
credentials an employee only able to work a partial work shift due to work-related injury is
classified as? - ✔✔restricted work activity. The number of recordable injuries and illness
per 100 full time workers is known as? - ✔✔incident rate when managers know and follow
safety and health rules are demonstrating: - ✔✔management leadership and commitment
to safety and health Safety and Heath program and jobsites inspections by competent
person are 2 main components of _____ - ✔✔An employers accident prevention
responsibilities 100 ft is the maximum ___ from any protected point to the nearest fire
extinguisher - ✔✔travel distance _____ signs such as danger and caution shall be visible
when work is being performed - ✔✔Accident prevention A personal fall arrest system shall
bring an employee to a complete stop and limit the ___ 3.5 feet. - ✔✔max deceleration
distance Whether paid for by employer or employee, all ____ shall be maintained in a safe
condition - ✔✔Hand and power tools ____ shall be shielded to protect employees and
other persons working in the vicinity. - ✔✔Arc welding and cutting Failure to inspect for
_____ on regulation fitting, valves , on the cap thread on a cylinder of oxygen can result in
fire - ✔✔oil and grease PFAS, when stopping a fall, shall be ____ that the employee cannot
fall more than 6ft or contact a lower level - ✔✔rigged such when _____ is/are used
perpendicular to a roof edge, the warning lines cannot be closer than ft. - ✔✔mechanical
equipment A ___ deals with the cord-set and receptacles which are not part of the
permanent wiring of a building or structure - ✔✔assured equipment grounding conductor
program electrical equipment that operates at 50 volts or higher shall be ___ against
accident contact. - ✔✔Guarded subpart V states that work to be preformed that is __ shall
have a job briefing held before the start of day or shift - ✔✔repetitive or similar Bonding is
the practice of connecting two ___ objects to prevent static sparks - ✔✔metallic when
scaffolding is being erected, moved, dismantled, or altered it shall be ___ by competent
person. - ✔✔Supervised Top rail of a guardrail system must be 42 inches +/- _____ above a
, walking/ working level - ✔✔3 inches a sandy clay loam that has an unconfined
compressive strength of 1.2 tsf would be classified as - ✔✔Class B soil Type A soil can be
sloped 1/1:2 ration if the excavation is open less than___ and is less than 12 feet in depth -
✔✔24 hours cross bracing on scaffolding is acceptable as a midrail when the cross point is
20-30 inches above the walking surface and - ✔✔end point are less than 48 inches apart
The results of work place injury and illness may include: - ✔✔lower morale and increase
cost to train and replace workers Osha Mission is to - ✔✔Protect the safety and health of
American workers The right of workers to seek safety and health on the job without fear of
punishment can be found in? - ✔✔section (c) of the OSHA ACT when was the OSHA Act
sign into law? - ✔✔1970 The employers responsibility to provide a workplace free from
recognized safety and health hazard is also know as - ✔✔General Duty Clause Horizontal
standards apply: - ✔✔When a condition is not covered by a specific industry standard
Vertical Standards apply: - ✔✔Only applies to specific industry standards. Horizontal Ex: -
✔✔working surface, fire protection, and first aid vertical ex: - ✔✔Longshore or
construction industry The purpose of OSHA Directives, including enforcement and
compliance directives CPL is to: - ✔✔ensure consistent enforcement of OSHA regulation
OSHA requires that employees certify that abetment is complete: - ✔✔for each cited
violation what would result in a "creating " employer receiving a citation under OSHA multi-
employer citation policy for damaging a guardrail exposing exposing all employees to a fall
hazard - ✔✔creating employer failed to inform employees, other than it worker, of the
damaged guardrail in addition to the presentation of credential, the inspection process
includes: - ✔✔The opening conference, the walkaround inspection, and he closing
conference The conduct of diagnostic procedures are recordable? T or F - ✔✔False 3 types
of first aid procedures - ✔✔nonprescription meds, clean a wound, bandage what form has
to posted from February 1st to April 30 of the following year - ✔✔OSHA 300 (a) log As a
result of a work-related illness or injury what would be classified as restricted work activity
(not including the day the illness or injury began) - ✔✔Days the employee was only able to
work partial work shift in OSHA recordkeeping, an incident rate is: - ✔✔The number of
recordable injuries per 100 full-time workers what are the four major elements of safety
and health program - ✔✔management commitment and employee involvement, worksite
analysis, hazard prevention and controls, and safety and health training To demonstrate
management leadership and commitment to safety and health, managers should: - ✔✔be
an example by knowing and following the rule employees are expected to follow. the two
main components of an employers accident prevention responsibilities required by
1926.20 (b) are: - ✔✔a safety and health program and jobsite inspection by a competent