Neiep 535 Freight Elevator Doors and
Gates Exam/ 49 Q&A, 2025.
For Class A loading, no piece of freight can be more _______ of rated load. -
Answer: 25%
Loads for Class A are transported on an off of the platform _______ - Answer:
Manually
Trucks or automobiles on Class B freight platforms cannot exceed _______ of
rated load. - Answer: 75 %
Page 1 of 7
, When securing the bolts to the guide rails , always locate the bolts _______ of the
rail mounting slot. - Answer: At the top
Door motor and sheaves should be in place before the door panels are put in
place. - Answer: True
When hoisting lower door panels with truckable sills, wire rope is wrapped around
the _______. - Answer: Trucking sill extension
When lower panels are installed, they should be set on the sill stops and the top
edge of the panel adjusted to _______ the landing sill level. - Answer: Level with
If lower panels are installed with guide stops, they should be set on the guide
stops and the panel upper edge should be adjusted to _______ the landing sill
level. - Answer: 1/8 inch below
When balancing both vertically bi-parting freight doors, they should be set with a
slight tendency to drift _______ - Answer: Open
The _______ prevents the door from opening when the retiring cam is not on the
interlock roller. - Answer: Keeper
The top of the gate posts are held in place by framing that is connected to the
_______ - Answer: Crosshead
Page 2 of 7
Gates Exam/ 49 Q&A, 2025.
For Class A loading, no piece of freight can be more _______ of rated load. -
Answer: 25%
Loads for Class A are transported on an off of the platform _______ - Answer:
Manually
Trucks or automobiles on Class B freight platforms cannot exceed _______ of
rated load. - Answer: 75 %
Page 1 of 7
, When securing the bolts to the guide rails , always locate the bolts _______ of the
rail mounting slot. - Answer: At the top
Door motor and sheaves should be in place before the door panels are put in
place. - Answer: True
When hoisting lower door panels with truckable sills, wire rope is wrapped around
the _______. - Answer: Trucking sill extension
When lower panels are installed, they should be set on the sill stops and the top
edge of the panel adjusted to _______ the landing sill level. - Answer: Level with
If lower panels are installed with guide stops, they should be set on the guide
stops and the panel upper edge should be adjusted to _______ the landing sill
level. - Answer: 1/8 inch below
When balancing both vertically bi-parting freight doors, they should be set with a
slight tendency to drift _______ - Answer: Open
The _______ prevents the door from opening when the retiring cam is not on the
interlock roller. - Answer: Keeper
The top of the gate posts are held in place by framing that is connected to the
_______ - Answer: Crosshead
Page 2 of 7
