Fire Pump Run Test Practice Quiz with 100% Correct Answers

Fire Pump Run Test Practice Quiz with 100% Correct Answers Heat exchangers shall be checked for __________ water flow. - Answer️️ - cooling All alarm pilot lights should be in what state? - Answer️️ -Off There are two requirements listed under pump house conditions: - Answer️️ -Ventilating louvers are free to operate & Heat is adequate, at least 40°F for diesel pump rooms __________ inspection requires verification that the pump suction discharge and bypass valves should be fully open. - Answer️️ -Weekly When verifying the electrical system conditions, the controller pilot should be: - Answer️️ -Illuminated (power on) Pump packing boxes, bearings and casing shall be checked for __________. - Answer️️ -overheating What kind of pump do you record the time crank? - Answer️️ -Diesel The pertinent visual observation categories required to be inspected weekly checklists are: - Answer️️ -Pump house conditions, pump system ©SOPHIABENNETT@ Saturday, August 24, 2024 8:52 AM 2 conditions, electrical system conditions, diesel engine system conditions, steam engine conditions What is the purpose of inspecting the pump assembly? - Answer️️ -To confirm it appears to be in operating condition and is free from physical damage True or False? The transfer switch normal pilot light should be illuminated. - Answer️️ - True The purpose of testing the pump assembly is to ensure automatic manual operation upon demand and continuous delivery of the required system output. An additional purpose is to __________. - Answer️️ -detect deficiencies not evident by inspection At what level should the oil level in the vertical motor sight glass be? - Answer️️ -Normal/Acceptable range True or False? The isolating switch for electric pumps should be closed. - Answer️️ -True True or False? ©SOPHIABENNETT@ Saturday, August 24, 2024 8:52 AM 3 When verifying water level in suction reservoir during weekly inspection, the water level should be full. - Answer️️ -True Diesel engine fuel tank level, float switch and solenoid valve operation shall be checked __________. - Answer️️ -weekly (visual inspection) Controllers include air-, __________ or electric- operated units. - Answer️️ -hydraulic- The weekly test pertinent adjustments shall be made while the pump is: - Answer️️ -running True or False? The oil level in the right angle gear drive should be normal/acceptable range. - Answer️️ -True The normal phase rotation pilot should be: - Answer️️ -on The reverse phase alarm pilot light for electric pumps should be: - Answer️️ -off The controller selector switch should be in the __________ position. - Answer️️ -auto The number of engine operating hours is measured by the: - Answer️️ - engine running time meter ©SOPHIABENNETT@ Saturday, August 24, 2024 8:52 AM 4 Types of centrifugal fire pumps include __________ and __________ units of __________ and __________ shaft design. - Answer️️ -single and multistage; horizontal and vertical True or False? The fire pump shall be started manually for the test run. - Answer️️ -False Diesel fire pumps are required to be test ran weekly for __________ minutes. - Answer️️ -30 A valve installed as a safety valve shall: - Answer️️ -permit to